STEP 5 (See Diagram 5 & Cable Loop Diagram)

A.)

Attach the 205” Upper Cable (#35) to the opening at the front of the Upper

 

Frame (#5). Note: The Ball Stopper on the cable need to be underneath the

 

Frame.

B.)

Attach a Pulley (#51) to the opening. Secure it with one M10 x 4 1/8” Allen Bolt

 

(#77), two Ø ¾” Washers (#91), and one M10 Aircraft Nut (#94).

C.)

Draw the Cable towards the back of the machine to the opening on the Upper

 

Frame. Repeat B to install a Pulley.

D.)

Draw the Cable around the Pulley then pull back towards the open bracket on

 

the Front Press Base (#5).

E.)

Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#81),

 

two Ø ¾” Washers (#91), and one M10 Aircraft Nut (#94).

F.)

Draw the Cable around the Pulley then to the opening on the Front Vertical

 

Frame (#2). Repeat Procedure B above to install another Pulley.

G.)

Draw the Cable around the Pulley and back to the lower open bracket on Front

 

Press Base. Repeat Procedure E to install a Pulley.

H.)

Draw the Cable around the Pulley and back to the open bracket on the back of

 

Front Vertical Frame. Repeat Procedure E to install a Pulley.

I.)

Draw the Cable around the Pulley then downward. Attach the Cable to in

 

between the two Double Floating Pulley Brackets (#20). Repeat Procedure E to

 

install a Pulley. Let the bracket hanging for now.

J.)

Draw the Cable around the Pulley then pull the Cable upward to the open

 

bracket on the Rear Vertical Frame (#3). Repeat Procedure E to install a Pulley.

K.)

Draw the Cable around the Pulley Along the Upper Cross Brace to the open

 

bracket on the Upper Cross Brace (#15). Repeat Procedure E to install a Pulley.

L.)

Draw the Cable to the opening on the Weight Stack Frame (#17). Repeat B to

 

install a Small Pulley (#50) to the opening.

M.)

Pull the Cable downward between the two Guide Rods, to the Selector Rod

 

(#24). Fully thread the bolt at the end of the Cable into the top opening on the

 

Selector Rod.

N.)

Use the Weight Selector Pin (#63) to select the number of Weight Plates to

 

exercise. Please refer to the Weight Resistance Chart in page-24.

14

Page 15
Image 15
Impex MWM-7300 manual See Diagram 5 & Cable Loop Diagram, Frame