STEP 8 (See Diagram 8 & Cable Loop Diagram)
A.) | Attach the 161” Lower Cable (#27) to the opening on the bottom of the Leg |
| Developer (#11). |
B.) | Attach a Pulley (#64) to the opening. Secure it with one M10 x 2 ½” Allen Bolt |
| (#68), two ∅ 7/8” Pulley Bushings (#44), and one M10 Aircraft Nut (#84). |
C.) | Draw the Cable underneath the Pulley towards the back of the machine to the |
| opening on the bottom of the Main Base Frame (#1). Install a Pulley as |
| described in Step B above. |
D.) | Draw the Cable underneath the Pulley. Insert the Cable through the rectangular |
| tube and the hole on the bottom of the Vertical Beam to the second open bracket |
| under the Main Base Frame. |
E.) | Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾” Allen Bolt (#69), |
| two ∅ ¾” Washers (#81), and one M10 Aircraft Nut (#84). |
F.) | Pull the Cable upward to the Double Floating Pulley Brackets (#20) previously |
| installed in Step 6. Install another Pulley. Use any hole on the Bracket for now. |
| After completing the Cable installation, come back to this Pulley and adjust the |
| position. If the Cable loop is too loose, move the Pulley up on the Bracket. If the |
| Cable loop is too tight, move the Pulley down on the Bracket. |
G.) | Draw the Cable around the Pulley then downward. Attach the Cable to another |
| Single Floating Pulley Bracket (#22). Install another Pulley. Let the Bracket |
| hanging for now. |
H.) | Pull the Cable around the Pulley then upward to the Single Floating Pulley |
| Bracket (#22) previously in Step 7. Secure the end of the Cable to the Bracket |
| with one M10 x 1 1/8” Allen Bolt (#71), two ∅ ¾” Washers (#81), and one M10 |
| Aircraft Nut (#84). |
12
