Cleaning and Special Maintenance
Filter Assembly
For best performance and results, the filter assembly must be cleaned .
The filter efficiently removes food particles from the wash water, allowing it
to be recirculated during the cycle. For this reason, it is a good idea to
remove the
larger food particles trapped in the filter after each wash cycle by rinsing the
"A"
To clean the filter and the fine filter, use a cleaning brush. Then, reassemble the filter parts as shown in the figures below and reinsert the entire assembly in the dishwasher,
positioning in its seat and |
| |
| ||
pressing downward. |
| |
The dishwasher must | A | |
never be used without the | ||
filters. | Improper | |
replacement of the filters |
| |
may reduce the perfor- |
| |
mance | level of the | B |
appliance and damage | ||
dishes and utensils. | ||
Cleaning the Sprayer |
| |
Arms |
|
|
It may happen that food particle become encrusted on the sprayer arms and block the holes (see "Close up view (interior)", letters
Cleaning the Water Inlet Filter
Periodically clean the water inlet filter (see figure 2 under "Installation") located on the outlet of the water supply tap. After turning off the water tap, unscrew the end of the water supply hose, remove the filter and clean it carefully under running water. Then, return the filter to its place and tighten the water supply hose back into position.
Troubleshooting
It may occur that the dishwasher does not function or does not function properly. Before calling for assistance, let us see what can be done first.
The Dishwasher Does Not Start
Have you checked whether:
-the plug is pushed into the socket correctly;
-the power is on in the house;
-the door is closed properly;
-the
-the water supply is turned on.
The Dishwasher Does Not Load Water
Have you checked whether:
-the water is turned on and the hose is connected properly;
-the water supply to the house is on and has sufficient pressure;
-the water supply hose is crimped or bent;
-the filter for the water supply hose is clogged.
The Dishes Are Not Clean
Have you put the right amount of detergent into the dispenser?
Is the wash cycle suitable for the dishes you have placed inside the appliance?
Are the filter and microfilter clean? Can the sprayer arms turn freely?
The Dishwasher Does Not Drain
Have you checked whether:
- the drain hose is crimped or bent.
Lime Deposits or a White Film Form on the Dishes
Have you checked whether:
-the lid to the salt container is closed properly;
-the rinse aid dosage is correct.
Error messages
The dishwasher is equipped with a safety system which is able to detect any operating anomalies. These anomalies are signalled by some messages flashing on the counter. When H2O is flashing, you should cancel the wash cycle as described in the paragraph entitled “Cancelling or modifying a wash cycle in progress”, then check whether there is any water in the mains supply and that the water tap has been turned on. Restart the appliance following the instructions provided and if the message persists, then call for Technical Assistance. In all other cases, remember the message which is flashing on the counter, turn the appliance off and call for technical assistance, stating which message was flashing.
If, despite all these checks, the dishwasher still does not function and/or the problem persists, contact the nearest authorised service centre and provide them with the following information:
-the nature of the problem;
-the model type number (Mod. ...) and the serial number (S/N ....), which are indicated on the plate located on the side of the inner part of the door.
Never call on unauthorised technicians and refuse to allow parts to be installed that are not original spare parts.
11 | GB |