Indesit DE 73 Turning on the Appliance, How to start a wash cycle…, If you have left out a dish…

Turning on the Appliance

How to start a wash cycle…

After performing all the operations described in the previous chapters, turn the water tap on completely, press ON-OFF button "A" situated on the control panel, indicator light "B" comes on.

The display turns on and the 3 dashes appear, indicating that the dishwasher is awaiting instructions.

Starting and setting the cycle.

Turn the cycle selector "M" until the reference notch on the knob corresponds with the symbol or number of the cycle you wish to set (consult the wash cycle table contained in this manual, especially when first using the appliance).

After a few seconds, a beep indicates the wash cycle has started and indicator "G" displays the phase with which it has begun. The counter "L" will indicate the amount of time left until the end of the wash cycle.

Cancelling or modifying a wash cycle in progress…..

Premise: a wash cycle in progress can only be modified if it hasn't been running for long.

To modify a wash cycle in progress, turn knob "M" until it reaches the RESET position.

After a few seconds, you will hear 4 beeps, indicator "G" relating to the phase under way will come off and 3 dashes will appear. At this point, all the settings will have been cancelled.

To select a new wash cycle, repeat the instructions contained in the paragraph entitled "Starting and setting the cycle"

If you have left out a dish…

You can interrupt a wash cycle by pressing the ON-OFF button, then place the forgotten dishes into the appliance, which will start up from where it was interrupted when you turn it back on.

Cycle phase underway indicator

Your dishwasher is equipped with an indicator "G" comprising 4 symbols which represent the different phases of a wash cycle. When the wash cycle has started, the display will indi- cate the phases underway in sequence.

These phases are:

pre-wash, wash, rinses, drying.

At the end of the wash cycle….

The end of the wash cycle is signalled by 2 beeps, and a flashing "END" will come up on the display. Bring the selector back to the RESET position, and the 3 dashes for programming cancellation will appear.

Turn the appliance off by pressing the ON-OFF button, turn off the water tap and open the door. Wait a few minutes before removing the dishes: this way you won't have to handle them while they're still hot and they will dry better.

How to eliminate the drying phase.

To eliminate the drying phase from the wash cycle you wish to start, just turn the knob to the Reset position then first and foremost set any preferences as to:

Þupper or lower rack

Þdelayed start

Start the wash cycle by following the instructions. Symbol

relating to the drying phase will flash for approximately 4 seconds; immediately press button "I" and the symbol will

disappear, thus indicating that the drying phase has been

eliminated.

7 GB