INSTALLATION INSTRUCTIONS
INTRODUCTION
Step 1: Prepare installation
Do not lift the oven by the door handle.
Whilst every care is taken to eliminate burrs and raw edges from this product, please take care when handling - we recommend the use of protective gloves during installation.
Please note that all dimensions and sizes given are nominal - some variation is to be expected.
If the appliance is to be installed near to a corner where the adjacent cabinets run at right angles forward of the appliance, there must be a gap of at least 90mm between the appliance and the cabinets, to prevent overheating of the cabinets.
1.Remove the fixing screws from the polythene bag on the top of the appliance, but leave the appliance in the base tray packaging until you are ready to install it.
Note: When removing the appliance from the base tray packaging care should be taken to ensure the outer frame trim is not damaged.
2.(i) When installed in a typical 600mm deep built in housing unit, the false back should be removed from the housing unit, to provide the necessary depth for installation.
(ii)When the false back is removed, it is normally the case that the support shelf for the appliance leaves a gap between the back edge and the wall of approximately 80mm.
(iii)If no gap occurs between the back edge of the shelf and the wall behind the unit, we recommend that a gap of at least 30mm is made by short- ening the shelf.
To replace an oven light bulb
Caution: Switch off the electricity supply to the appliance at the socket, to avoid the risk of electric shock. Wait until the oven is cool, then remove the oven shelves.
Main oven only - remove the loose oven back - unscrew the 4 securing screws (one at each corner).
Unscrew the lens cover (turn anticlock- wise). Unscrew the bulb and replace.
Replace lens cover.
Main oven only - replace oven back.
Please note that the oven light bulb is not covered by the guarantee.
Before using the appliance for the first time, remove any protective polythene film and wash the oven shelves and furniture in hot soapy water to remove their protective covering of oil. Even so, when you first switch on the oven or grill you may notice a smell and some smoke.
Glass door panels
To meet the relevant standards of Domestic cooking appliances, all the glass panels on this appliance are toughened to meet the fragmentation requirements of BS 3193. This ensures that, in the unlikely event that a panel breaks, it does so into small fragments to minimise the risk of injury.
Please take care when handling, using or cleaning all glass panels as any damage to the surfaces or edges may result in the glass breaking without warning or apparent cause at a later date. Should any glass panel be damaged, we strongly recommend that it is replaced immediately.
Disposal of packaging
• All our packaging materials are | |||
recyclable | and | environmentally | |
friendly. |
|
|
|
• Please help | us | to protect our | |
environment by disposing of all | |||
packaging | in | an | environmentally |
friendly manner. |
| ||
• Please contact your local authority | |||
for the nearest recycling centre. | |||
Front of oven
22
Rear Wall |
30 - 80 |
mm |
Back edge of support shelf
Caution: Packaging materials can pose a risk of suffocation - keep away from children.
3
