clockwise, till to the position “Max”.
It is necessary to hold pressed in the knob for about 6 seconds in order to activate the flame failure device. To light on the grill burner press in the bottom marked
by the symbol 
, press deeply and turn the oven knob
counter clock wise till to the position 
(grill).
It is necessary to hold pressed in the knob for about 6 seconds in order to activate the flame failure device. In case of lack of electricity light the oven or grill manuall, following the instruction of “the oven knob paragraph”.
The rotisserie (only a few models)
When using the rotisserie act in this way:
a)fit supporting hook into the two holes in the lower side of the grill protection (position A);
b)fit the spit into the hole in the centre of the back of the oven, making sure that the fore clasping link of the spit is correctly positioned on the supporting hook (position B);
c)start up the rotisserie by pressing the botton "O".
Oven light button (O)
This is marked by the symbol 
and switchs on the light inside the oven so that you can control the cooking without opening the door.
Timer Knob (only a few models)
To use the timer, the ringer "S" must be wound up by turn- ing the knob one full turn clockwise 
; then turn it back
, to the desired time so that the number of minutes on the knob matches the reference mark on the panel.
Attention
Avoid the children touch the oven door because it is very hot during the cooking.
Practical advice for burner use
In order to get the maximum yield it is important to remember the following:
·Use appropriate cookware for each burner (see table) so as to avoid flames overshooting the edges.
·At boiling point turn the knob to minimum.
·Use cookware with lids.
·Always use cookware with flat bottoms.
Burner | ø Cookware Diameter (cm) |
|
|
Fast (R) | 24 - 26 |
|
|
Semi Fast (S) | 16 - 20 |
|
|
Auxiliary (A) | 10 - 14 |
|
|
Triple Crown (TC) | 24 - 26 |
|
|
N.B. On the models supplied with a reducer shelf, remember that this should be used only for the auxiliary burner when you use casserole dishes with a diameter under 12 cm.
Electronic timer
The electronic timer displays the time and the timer function with countdown.
Note: all the functions are operative approximately 7 seconds after they are stet.
How to reset the clock
After the appliance has been connected to the power supply, or when the power has gone out, the clock display will automatically reset to 0:00 and begin to blink. 0 00
• Press the 
button, and then use the and 
buttons to set the correct time. To move the time forward quickly, keep the buttons pressed.
Whenever the time must be reset, follow this same procedure.
Timer Feature
Press the 
button to access this function. The symbol "
" will appear on the display. Each time you press button
, the time will increase by 10 seconds until 99 minutes and 50 seconds. If you continue to press it, the time will increase from minute to minute up to a maximum of 10 hours.
Use button to go backwards.
After setting the desired time, start the countdown. When the time has elapsed, the buzzer will sound, and it can be interrupted by pressing any of the buttons.
You can display the time by pressing button 
, and symbol "
" indicates the timer function has been set. After approximately 7 seconds, the display automatically goes back to indicating the timer.
To cancel a previous setting
Press button |
| up until 0 • 00. |
|
12
