c)Minimum regulation of the hob burners:
• turn the tap to minimum;
• remove the knob and adjust the regulation screw, which is positioned in or next to the tap pin, until the flame is small but steady.
N.B.: in the case of liquid gas, the regulation screw must be screwed in to the bottom.
• check that the flame does not turn off when you turn the tap quickly from high to low.
d)Regulating the primary air of the burners:
The primary air of the burners requires no regulation.
Adapting the gas oven to different types of gas
a)Replacing the oven burner nozzle:
• remove the warming drawer;
• in the case of models without warming drawer, remove the panel “P” as indicated in Fig. A. Open the door, release the two top inserts by pressing them downwards, and then the two bottom inserts by pressing them upwards.
• remove the sliding protection “A”;
• remove the two screws to dismount the protection “B”; (see Fig. B);
• remove the screw and then the oven burner “V”(see Fig.C). Remove the oven door to facilitate this operation.
• unscrew the oven burner nozzle using the special socket spanner for the nozzles (see Fig. D), or better still a 7 mm socket spanner, and replace it with a nozzle suited to the new type of gas (see table 1).
A | B |
V
Fig. C | Fig. D |
b)Minimum regulation of the gas oven burner with thermostat (see fig.):
•light the burner as described in the paragraph“the oven knob” of the instruction booklet.
•turn the knob to Max for about 10 minutes and then turn the knob to the Min setting;
•remove the knob;
•regulate the screw positioned outside the thermostat pin until the flame is small but steady.
N.B.: in the case of liquid gas, the regulation screw must be screwed in to the bottom.
•check that the burner does not turn off when you turn the knob from Max to Min and and when you open and close the oven door quickly.
Adapting the gas grill to different types of gas Replacing the nozzle of the grill burner:
•remove the screw and then slide out the grill burner “V” (see Fig. E);
•unscrew the grill burner nozzle using the special socket spanner for the nozzles (see Fig. F) or better still a 7 mm socket spanner;replace the nozzle with a nozzle for the new type of gas (see table 1).
Fig. A | Fig. B |
V |
Fig. E
I |
Fig. F
6
