Indesit KP9 F11 S/G S manual Adapting to different types of gas, Safety Chain, Adapting the hob

	Adapting to different types of gas
GB
	It is possible to adapt the appliance to a type of gas other than
	the default type (this is indicated on the rating label on the cover).
	Adapting the hob
		Replacing the nozzles for the hob
		burners:
		1. Remove the hob grids and slide
		the burners off their seats.
		2. Unscrew the nozzles using a 7
		mm socket spanner (see figure), and
		replace them with nozzles suited to
		the new type of gas (see Burner and
		nozzle specifications table).
	3. Replace all the components by following the above
	instructions in reverse.

Adjusting the hob burners’ minimum setting:

1.Turn the tap to the minimum position.

2.Remove the knob and adjust the regulatory screw, which is positioned inside or next to the tap pin, until the flame is small but steady.

! If the appliance is connected to a liquid gas supply, the regulatory screw must be fastened as tightly as possible.

3.While the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame is not extinguished.

!The hob burners do not require primary air adjustment.

!After adjusting the appliance so it may be used with a different type of gas, replace the old rating label with a new one which corresponds to the new type of gas (these labels are available from Authorised Technical Assistance Centres).

!Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet hose in accordance with current national regulations relating to “regulators for channelled gas”.

Safety Chain

!In order to prevent the appliance from overturning accidentally, for example in case of a child climbing onto the oven door, the safety chains MUST be installed!

The cooker is provided with safety chains that must be fixed with a screw (not supplied as accessory) on the wall behind the appliance, at the same height as the fixing point on the appliance.

Make sure that the chains are fixed in the back of the cooker, as shown in the drawing, in such way to be tight and parallel to the floor.

!When the installation process is complete, the chains must be kept in tension!

TABLE OF CHARACTERISTICS

Afmetingen	32,9 x 59,5 x 39,6 cm
Oven HxLxP
Volume	lt. 78
Voltage and	230-240V~ 50/60Hz (see data plate)
frequency	Power supply Max 2400W
	Directive 2002/40/EC on the label of
	electric ovens.
	Standard EN 50304-60350
ENERGY	Energy consumption for
LABEL
	Natural convection – heating
	mode: Convection mode
	This appliance conforms to the following
	European Economic Community
	directives:
	- 2006/95/EEC dated 12/12/06 (Low
	Voltage) and subsequent amendments
	- 2004/108/EEC dated 15/12/04
	(Electromagnetic Compatibility) and
	subsequent amendments
	- 93/68/EEC dated 22/07/93 and
	subsequent amendments.
	- 2009/142/EEC dated 30/11/09 (Gas)
	and subsequent amendments.
	- 2012/19/EEC and subsequent
	amendments.

6