Step Two

For Medium and Large Table Stand Assembly

Using the included Allen wrench, remove the bottom end cap

of the speaker by unscrewing the single center screw on bottom.

Step Four

For Medium and Large Table Stand Assembly Use screw and washer to attach medium

or large base assembly to the speaker assembly, as shown.

Satellite Speaker

End Cap

Infinity Logo

NOTE: The bottom is the side closest to the Infinity

1/4-20 x 3/4"

logo on the front grilleScrew and the speaker

connections on the rear.

Step Three

For Medium and Large Table Stand Assembly

Run speaker wire through collar. Using three screws, attach table stand plate to the medium or large section as shown.

(3) 1/4-20 x 7/8" Flat-Head Screws

Speaker Wire

Flat Washer

1/4-20 x 1"

Flat Washers

Pan-Head Screw

1/4-20 x 1"

1/4-20 x 3/4"

Pan-Head Screw

Pan-Head Screw

 

Step Five

For Medium and Large Table Stand Assembly

Run speaker wire through table stand plate. Use three screws (provided) to attach plate to bottom of base assembly.

Speaker Wire

(3) 1/4-20 x 7/8" Flat-Head Screws

TSS-SAT4000 7

Page 7
Image 7
Infinity TSS-SAT4000 manual Step Five, For Medium and Large Table Stand Assembly