Infinity TSS-SAT4000 manual Step Two, Step Three, Step Four, For Small Table Stand Assembly

Step Two

For Small Table Stand Assembly

Using the included Allen wrench, remove the bottom end cap

of the speaker by unscrewing the single center screw on bottom.

Satellite Speaker

End Cap

Infinity Logo

1/4-20 x 3/4" Screw

NOTE: The bottom is the side closest to the Infinity logo on the front grille and the speaker connections on the rear.

Step Three

For Small Table Stand Assembly

Assemble the table stand plate, the small section and the foot. Place three nuts (provided) in base of foot and secure them in place by three screws (provided) through the top of the table stand plate.

(3)1/4-20 x 7/8" Flat-Head Screws

Table Stand Plate

Small Section/Collar

Foot

(3) 1/4-20 Nuts

Step Four

For Small Table Stand Assembly

Run speaker wire through base, and screw foot assembly to speaker assembly.

Speaker Wire

1/4-20 x 1-1/4" Flat-Head Screw

6TSS-SAT4000