Infinity TSS-SAT4000 manual Wall-Mounting the SAT-4000 Using the Included Wall Bracket

Wall-Mounting the SAT-4000 Using the Included Wall Bracket

The customer is responsible for proper selection and use of mounting hardware, and for correctly and safely wall-mounting the speakers.

Step Four

Using the included Allen wrench, remove the bottom end cap

of the speaker by unscrewing the single center screw on bottom.

Step One

Remove the wall-bracket cover by removing the four wall bracket screws on the ends as shown.

End Cap

Satellite Speaker

Infinity Logo

End Cap

Step Two

Run the speaker wire behind the wall bracket and out the hole at the bottom. After deciding where to place the satellite speaker, attach the wall bracket (in a vertical position) to the wall

Wall Bracket

NOTE: The bottom is the side closest to the Infinity logo on the front grille and the speaker connections on the rear.

1/4-20 x 3/4" Screw

using the appropriate screws and anchors.

Mounting

Screws and

Anchors

Not Included

Bottom Hole

Step Five

Connect the wires (page 9). Replace the end caps while capturing the wall bracket in between parts A and B and securing it in place.Tighten until snug.

Step Three

Run the speaker wires out through the bottom hole of the wall bracket cover. Resecure in place as shown with four of the wall bracket screws.

Wall-Mount

End Cap A

Wall-Mount

End Cap B

8TSS-SAT4000