ASSEMBLY INSTRUCTIONS

INSTALLING THE CUTTING

ATTACHMENT SHIELD

Use the following instructions if the cutting attachment shield on your unit is not installed.

WARNING: Never operate the trimmer without the cutting attachment shield in place to prevent serious personal injury.

1.Slide the cutting attachment shield into the shield mount on the cutting attachment. Align the screw holes in the shield with the holes in the cutting attachment (Fig. 7).

Shaft Housing

Cutting

 

Attachment Shield

Shield Mount

Cutting Attachment

Fig. 7

2.Place a hex lock nut into one of the three recessed holes on the top of the cutting attachment shield (Fig 8).

Cutting Attachment Shield

Recessed Holes

Hex Lock Nut

Fig. 8

3.Install a screw into the hole from the bottom of the cutting attachment shield and screw it into the nut installed in step #2 (Fig 9). Do not tighten.

Screws

Fig. 9

4.Repeat steps 2 and 3 until all three screws have been started, then tighten securely.

11

Page 11
Image 11
Ryobi 767r, 775r manual Installing the Cutting Attachment Shield, Shaft Housing Cutting, Shield Mount