Ryobi Assembly Instructions, Installing and Adjusting the D-HANDLE Model 767r, Grip Wing Nut

ASSEMBLY INSTRUCTIONS

INSTALLING AND ADJUSTING THE D-HANDLE - MODEL 767r

1.Push the D-handle down onto the shaft housing so that the handle slants toward the powerhead (Fig. 1). The squared bolt hole in the handle is to the right.

Wing

Nut

BoltWasher

Fig. 1

2.Insert the shoulder bolt into the squared hole in the handle. Place the washer on the bolt, and screw the wing nut onto the bolt.

3.Rotate the D-handle to place the grip above the top of the shaft housing.

4.While holding the unit in the operating position (Fig. 2), position the D-handle to the location that provides you the best grip.

Model 767r

5.Tighten the wing nut (Fig. 3).

Grip

Wing Nut

Fig. 3

Fig. 2

9