![](/images/new-backgrounds/1201759/20175963x1.webp)
Using the Remote Control
learning
DVD VCR
SAT/CAB AUX AUDIO
CLEAR
C
1 | 2 | 3 |
4 | 5 | 6 |
7 | 8 | 9 |
0
REVERSE PLAY
STOP
You’ll use these buttons when you program the remote for other components.
Important Note: The remote may not be compatible with all models of all brands of components. It also may not operate all functions of your component.
Programming the Remote to Operate Other Components
The universal remote can be programmed to operate many brands of remote- controllable VCRs, audio components, DVD players, cable boxes, satellite receivers and other components.
The AUX button can be programmed to operate most brands of an additional
Note: The TV button can’t be programmed on this remote to control any component; it controls only this TV.
Find Out If You Need to Program the Remote
To determine whether the universal remote needs to be programmed to operate one of the components connected to your TV, such as a VCR, do the following:
1.Turn on the component (in this example, a VCR).
2.Point the remote at the component.
3.Press the corresponding component button (in this example, VCR).
4.Press ON•OFF to see if the VCR responds. If the VCR doesn’t respond, you need to program the remote to operate it.
Programming the Remote
There are two ways to program the remote control to operate other components: Automatic Code Search and Direct Entry.
Using Automatic Code Search
Note: The AUX button can only search VCR codes, but can be used for a
The following instructions can be used to program the remote to operate each of your components. If you want to stop the automatic code search without programming any of your components, press and hold CLEAR until the indicator on the remote turns off.
1.Turn on the component you want to operate (VCR, DVD player, etc.)
2.Press and hold the component button you want to program (VCR, DVD, etc.). While holding the component button, press and hold ON•OFF until the component button on the remote turns on, then release both buttons.
3.Point the remote at the component.
30 | Chapter 2 |