Settings menu

Sources: allows programming of source buttons, enables autosource, and enables the SCART RGB source. When Autosource is selected, the Source Enable feature indicates which sources the projector attempts to lock onto. You can use the

Source Enable feature to eliminate certain sources from this search, which will

 

Settings menu

 

 

speed the search. By default, the check boxes for all sources are checked except

 

 

SCART RGB. Uncheck a source box to eliminate it from the search. When Auto-

 

 

source is not checked, the projector defaults to Component initially, then defaults

 

 

to whatever the last active source was when the projector was powered down. To

 

 

display another source, you must manually select one by pressing the Source but-

 

 

ton on the remote. This cycles through all the sources that are selected in the

 

 

Source Enable menu.

 

 

The Source 1, 2, and 3 menus in the Sources menu allow you to assign a source to

 

 

the Source 1, 2, and 3 buttons on the remote. The Source 4 menu selection would

 

 

apply to the Custom key if that option is chosen in the Custom key menu, see

 

 

page 25. To use the SCART RGB source, you must first select it in the Source

 

 

Enable menu (the projector cannot automatically detect this source). Enabling

 

 

SCART will disable Component and Composite sources.

 

 

System>OSD Offset: allows you to adjust the position of the OSD. By default,

 

 

the menus are postponed in the upper lefthand corner of the displayed image and

 

Source

the messages are postponed in the lower lefthand corner. Adjust the offset to

Sources

move these items more to the right and middle of the display. Rear: reverses the

Enable

 

image so you can project from behind a translucent screen. Ceiling: turns the

 

 

image upside down for ceiling-mounted projection. Auto Ceiling: uses an internal

 

 

sensor to automatically turn on ceiling mount mode if the projector is inverted.

 

 

High Power: maximizes the light output of the lamp. Auto Power: When Auto

 

 

Power is checked, the projector automatically goes into the startup state after the

 

System menu

projector receives power. This allows control of ceiling mounted projectors with a

 

 

wall power switch.

 

 

24