InFocus IN82 Select, Custom, Custom, Service, HDMI DDC, Blue Only, Serial Port, Source Info, Test Pattern, Service Info, Service Code, Factory Reset, Reset Lamp hours

Service: To use these features, highlight them and press Select.

Factory Reset: restores all settings to their default.

Reset Lamp hours: resets the lamp hours used counter in the Service Info menu to zero. Do this only after changing the lamp.

Test Pattern: displays a test pattern. To display test patterns, first you must assign Blank Screen to the Custom key (page 25), then click the Test pattern check box in the Service menu to turn the option on, exit the menus, then press the Custom button on the remote. To select the patterns, use the up/ down arrows on the remote. To exit the test patterns, press the Custom button.

Blue Only: turns off the Red and Green portions of the input, allowing you to properly adjust the color balance with a SMPTE color bar pattern.

HDMI DDC: turns the EDID extension on and off. Some graphic cards cannot recognize the projector’s EDID. By default, the extensions are on (check- boxes are checked). Change these settings if you have trouble using HDMI or DVI sources.

Serial Port: allows you to select the baud rate to accommodate some older, slower external control systems.

Service Info: provides information about the projector’s software, serial number, and lamp.

Service Code: only used by authorized service personnel.

Source Info: provides information about the active source.

Service menu

HDMI menu

Serial Port menu

Service Info

Source Info menu

26