OPERATOR’S MANUAL
SECTION M10
MANUAL 43
Released: 5/79
INCLUDING: OPERATION,INSTALLATION& MAINTENANCE | Revised: | ||
|
| ||
“22” SERIES SHORT | GRINDERS | Form: |
|
|
| ||
Models: |
|
| |
and |
|
| |
READ THIS MANUAL CAREFULLY BEFORE INSTALLING, OPERATING OR SERVICING THIS EQUIPMENT.
FAILURE TO OBSERVE THE FOLLOWING
To aid the operator’s understanding of proper and safe use of grinders, the publications, “Use,Care and Protection of Abrasive Wheels”, A.N.S.I. B7.1, and “SafetyCode for Portable Air Tools”, A.N.S.I. B186.1, can be purchased from:
American National Standards Institute, Inc.
1430 Broadway
New York, New York 10018
Operate this tool at 90 p.s.i.g. (6.2 bar) maximum air pressure at the air inlet of the tool..
Disconnect air supply from tool before removing/installing wire brush or rotary file or performing other maintenance pro- cedures.
Keep hands, clothing and tong hair away from rotating end of tool.
Anticipate and be alert for sudden changes in motion during start up and operation of any power tool.
Never exceed rated r.p.m. of tool.
Wear suitable eye and hearing protection while operating tool. Tool shaft can continue to rotate briefly after throttle is re- leased.
Do not lubricate tools with flammable orvolatile liquids such as kerosene, diesel or jet fuel.
Use tool only for purposes for which it was intended.
WARNINGS COULD RESULT IN INJURY.
lDo not use excessive work pressure.
lDo not remove any labels. Replace any damaged label. l Use only accessories recommended by ARO.
Repeated prolonged operator exposure to vibrations which may be generated in the use of certain
The use of other than genuine ARO replacement parts may result in safety hazards, decreased tool performance and in- creased maintenance and may invalidate all warranties.
ARO is not responsible for customer modification of tools for applications on which ARO was not consulted.
Tool maintenance and repair should be performed by autho- rized, trained, competent personnel. Consult your nearest ARO authorized servicenter.
It is the responsibility of the employer to place the information in this manual into the hands of the operator.
For parts and service information, | contact your local ARO distributor, or the Customer Service Dept. of the | |
Center, White House, TN at PH: | (615) | |
|
| |
ARO Tool Products
1725 U.S. No. 1 North l P.O. Box 8000 l Southern Pines, NC 283888000
©1995 THE ARO CORPORATION l PRINTED IN U.S.A.
