Ingersoll-Rand S120-EU SAW Specific Warnings, Adjustments, Placing Tool in Service, Lubrication

SAW SPECIFIC WARNINGS (Continued)

•Keep hands and clothing away from the blade.

The blade of a Circular Saw will coast before stopping after the throttle is released.

•Do not stop rotation of blade by putting lateral pressure on it.

•Operate the Saw only when standing on a stable platform and holding the Saw with two hands.

Do not operate the Saw while standing on a ladder.

•Rest the guide plate fully on the workpiece when operating.

•Do not force the Saw into the workpiece. The Saw may kick back if the blade is forced or pinched while making a cut.

•Always use genuine Ingersoll–Rand Flanges provided with the Saw. Never use a substitute.

•Mount the blade and flanges as instructed in this manual. Always mount the blade so that the arrow on the blade and the arrow on the Swing Guard point in the same direction.

•Never operate the Saw without the Flange Retaining Screw installed in its proper place in the end of the Arbor. Always securely tighten the Flange Retaining Screw as instructed in this manual before operating the Saw.

•Do not use saws in a bench mounted configuration.

ADJUSTMENTS

OILER ADJUSTMENT

The built–in lubricator has been properly adjusted at the factory to produce the correct amount of lubrication for the tool. Insufficient lubrication can result from clogged oiler felts within the lubricator. To replace the felts, proceed as follows:

1.Remove the Drain Plug and pour the oil from the oil chamber.

2.With a thin blade screwdriver, remove the Oiler Adjusting Screw.

3.Using tweezers or a bent piece of wire, remove the Oiler Felts and install a new set.

4.Replace the Oiler Adjusting Screw, installing it slightly below flush, and replace the wool.

5.Replenish the oil supply and install the Drain Plug.

PLACING TOOL IN SERVICE

LUBRICATION

Ingersoll–Rand No. 50 Ingersoll–Rand No. 28

Always use an air line lubricator with these tools.

After each year of service, clean all grease from the gearing and replace it with 3 to 4 cc of fresh Ingersoll–Rand No. 28 Grease.

MAIN LINES 3 TIMES

AIR TOOL INLET SIZE

We recommend the following Filter–Lubricator–Regulator Unit:

International – No. FRL30–C6–A29

Where a permanent lubricator cannot be installed, inject

3 cc of Ingersoll–Rand No. 50 Oil into the air inlet before attaching the hose. Remove the Drain Plug from the Motor Housing and fill the chamber. After each eight hours of operation, replenish the oil supply.

TO

AIR

SYSTEM

TO

AIR

TOOL

LUBRICATOR

REGULATOR

FILTER

Whenever the Saw is disassembled for maintenance or repair, work 3 to 4 cc of Ingersoll–Rand No. 28 Grease around the Arbor Gear and Rear Arbor Bearing.

After each forty–eight hours of operation, inject five or six strokes of Ingersoll–Rand No. 28 Grease into the Grease Fitting.

BRANCH LINE 2 TIMES

AIR TOOL INLET SIZE

DRAIN REGULARLY COMPRESSOR

(Dwg. TPD905–1)

3