Initio INI-9090U manual

initio

Users Manual

initio

INI-9090U

Contents

Main ii iii Contents iv Contents 1 Introduction The Initio INI-9090U Host Adapter Page Product Features/Specifications Product Features Product Features/Specifications Product Specifications Getting Started Host Adapter and the SCSI Bus SCSI bus preparation SCSI bus termination Getting Started Installation Basics Installation in Ten Easy Steps Page Page Page Page Page Hard Disk Drive Preparation Low-level Format Running the SmartSCSI Setup Utility Main Menu Options Scan Bus Device Setup Adapter Setup BIOS Setup Page 17 Installing the ASPI drivers to an existing MS-DOS system 18 Installing the Initio ASPI drivers to an existing Windows 3.1x system 19 ASPI Manager Command Line Options ASPI CD-ROM Driver Command Line Options 20 Autoexec.bat: 21 ASPI Disk Driver Command Line Options 22 ASPI Partition & Format Utility 23 New Windows 95/95a Installation Page 25 Adding the Initio Driver to an Existing Windows 95/95a System 26 Updating the Initio Windows 95/95a Device Driver 27 New Windows 95B (OSR2) Installation 28 Adding the Initio Driver to an Existing Windows 95B (OSR2) System 29 Updating the Initio Windows 95B (OSR2) Device Driver Page 31 New Windows NT Installation 32 Adding or updating the Initio driver to an existing Windows NT system: 33 Installing a new Windows NT system and Initio driver without floppy disks 34 Installing a new Windows NT system from a Bootable CD 35 New IntraNetWare Installation 36 Adding the Initio driver to an existing IntraNetWare system 37 Upgrading/Changing Driver on an Existing IntraNetWare Server 38 Device driver command line options Driver Config Options: 39 New OS/2 installation: 40 Adding the Initio driver to an existing OS/2 system 41 Device driver command line options Driver Config Options: Page 43 Updating interrupts and hardware settings 44 Installing the Initio driver in a new SCO UNIX system Adding the Initio driver to an existing SCO UNIX system 45 Changing to the INI-9XXX as the bootable host adapter: Page 47 Updating interrupts and hardware settings Installing the Initio driver in a new UnixWare system 48 Adding the Initio driver to an existing UnixWare system 49 Using Multiple Host Adapters Removing the Initio driver from a UnixWare system 2 Then rebuild the UnixWare kernel by executing the following commands at the system prompt: Linux Drivers Page Page Troubleshooting B: DOS Space > 1GB MS-DOS, OS/2 & Windows NT SCO UNIX Page Page Index Page Product Warranty FCC Compliance Statement Class B Equipment Information to User Product Warranty Declaration of the Manufacturer/Importer EN 55 9100UW2 Declaration of Conformance