48
initio
®
2 When prompted to INSTALL HOST BUS ADAPTER DRIVERS, insert the INI-9XXXU/
9XXXUW DRIVER DISK 2 into drive A: press <Enter>.
3 When prompted to INSTALL ANOTHER HBA DISKETTE, press <ENTER> to con-
tinue.
4 Follow the directions on screen until you come to a window titled: Loading Initio INI-
9XXX Host Adapter.
Select CONTINUE INSTALLATION.
Select CONTINUE INSTALLATION again.
5 This completes loading the host adapter driver. Follow the on-screen directions to
complete the SCO UnixWare installation. For further information regarding UnixWare
installation, refer to the SCO UnixWare Installation Handbook.
Adding the Initio driver to an existing UnixWare system1 Once a UnixWare session is established and a command prompt is ready, type (recall
that UnixWare is case sensitive):
cp /stand/unix /stand/unix.org , press <ENTER>
pkgadd -d diskette1 , press <ENTER>
2 Select i910u ihv hba from the list of available host drivers, press <ENTER>.
3 If the INI-9XXX is intended to be the bootable host adapter, the next step to updating the
driver will require a revision to the I910u file. These instructions will guide you through
changing the current software settings for UnixWare to establish the INI-9XXX as the host
adapter for your boot device:
At the system command prompt, type
cd /etc/conf/sdevice.d
Use vi or another editor to modify the file I910u by adding a line
locate the line $version2
edit the file by adding the line $static immediately following $version2.
Rebuild the UnixWare kernel by completing the following steps at the command
prompt :
/etc/conf/bin/idbuild -B <ENTER>
cp /etc/conf/cf.d/unix /stand/unix <ENTER>
cd / <ENTER>
shutdown -g0 ( 0 is Zero ) <ENTER>
Y <ENTER>
SCO UnixWare Driver Installation