21
www.insignia-products.com

Cleaning discs

Fingerprints and dust on the disc can cause
poor picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe
the disc from the center out.
Do not use strong solvents such as alcohol,
benzine, thinner, commercially available
cleaners, or anti-static spray intended for older
vinyl records.

Resetting the DVD/VCR

Reset your DVD/VCR if you observe any of the
following symptoms:
• When the DVD/VCR is plugged in, but the
power will not turn on or off.
• When the display window does not work.
• When the DVD/VCR does not operate
normally.
To reset the DVD/VCR:
• Press and hold the POWER button for more
than five seconds. This forces the DVD/VCR
to turn off. Press the POWER button again to
turn the DVD/VCR back on.
- OR -
Unplug the power cord and then plug the
power cord again after more than five
seconds.
Specifications

General

Power requirements AC 120V, 60 Hz
Power consumption 16W
Dimensions (approx.) 16.9 × 3.1 × 10.2 in.
(w × h × d) (430 × 79 × 260 mm)
Mass (approx.) 8.8 lbs (4 kg)
Operating temperature 41°F to 104°F
(5°C to 40°C)
Operating humidity 5% to 90%
Signal system NTSC

VCR Specifications

Head system Four head helical
scan azimuth system
Timer 12-hour display type
with AM, PM
Tape speed SP: 33.35 mm/sec
LP: 16.67 mm/sec
SLP: 11.12 mm/sec
Tape width 12.7 mm
Rewind time About 3 min. (T-120)
Frequency range 20 Hz to 20 kHz
Signal-to-noise ratio > 43 dB
Dynamic range > 88 dB
Channel separation > 60 dB

DVD specifications

Laser system Semiconductor laser,
wavelength 650 nm
Frequency response DVD (PCM 96 kHz):
8 Hz to 44 kHz,
DVD (PCM 48 kHz):
8 Hz to 20 kHz
CD: 8 Hz to 20 kHz
Signal-to-noise ratio > 100 dB (Analog out)
Harmonic distortion < 0.008%
Dynamic range > 95 dB (DVD/CD)

Inputs

VIDEO IN (LINE1,2) 1.0 Vp-p 75 ohms, sync
negative, RCA jack × 2
AUDIO IN (LINE1,2) -6 dBm more than
47 ohms, RCA jack
(L, R) × 2

Outputs

VIDEO OUT 1 Vp-p 75 ohms, sync
neg., RCA jack × 1
S-VIDEO OUT (Y) 1.0 V (p-p),
75 ohms, neg. sync,
Mini DIN 4-pin × 1
(C) 0.286 V (p-p)
75 ohms
COMPONENT VID. OUT (Y) 1.0 V (p-p),
75 ohms, neg. sync,
RCA jack × 1
(PROGRESSIVE SCAN) (Pb)/(Pr) 0.7 V (p-p),
75 ohms, RCA jack × 2
Audio output (digital) 0.5 V (p-p), 75 ohms,
RCA jack × 1
Audio output (analog) 1.1 Vrms (1 kHz,
-6 dB), 600 ohms,
RCA jack (L, R) × 2

Accessories:

Video cable (1)
Audio cable (L, R)(1)
Remote Control (1)
Batteries (2)
Design and specifications are subject to change without
notice.
Legal notices

FCC compliance statement

This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
product is operated in a residential
installation.This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
NoteNever operate this product immediately after
moving it from a cold location to a warm location.
Leave it for two or three hours without operating it.
If you use this product in such a situation, it may
damage tapes, discs, or internal parts.
NS-DVDVCR.fm Page 21 Saturday, December 23, 2006 9:52 AM