Insignia
Installing the batteries
To install the batteries:
1Press in on the battery compartment cover, the lift the cover in the direction of the arrow to open the battery compartment.
2Insert two AA batteries into the battery compartment. Make sure that the + and – symbols on the batteries match the + and – symbols inside the battery compartment.
Setting up your TV combo
Connecting an antenna or basic cable TV
Warning
To avoid injury or damage to your TV combo, always unplug the antenna cable from the ANT. jack before you move your TV combo.
Use the following illustration to connect an antenna or basic cable TV (no cable box).
Antenna
OR
Cable TV
RF cable | Back of |
| TV combo |
OR |
|
| A N T . |
Incoming cable |
|
| Antenna |
Cables not included | selector (not |
included) |
Caution
Make sure that you match the + and – symbols on the batteries with the + and – symbols in the battery compartment. If you reverse the batteries, you may damage the remote control.
3Press down on the battery compartment cover until it clicks into place.
Warning
Do not throw the batteries into fire. Dispose of used batteries as hazardous waste.
Do not try to recharge batteries that are not rechargeable. The batteries may overheat and rupture.
If you do not plan to use your TV combo for a long period of time, remove the batteries to prevent damage or injury from leakage.
Note
Do not mix different types of batteries (for example, alkaline and
Do not mix old and new batteries.
Note
•If you use an antenna to receive analog TV, the same antenna generally will work for DTV reception.
•Outdoor or attic antennas get better reception than
•You cannot view some cable channels when your TV combo is connected to an aerial antenna because DTV programming does not cover all cable channels.You can watch these channels by switching to the cable connected to CATV.
•To easily switch between antenna and cable TV, purchase antenna selector.
8 |