2In Stop mode, press PROGRAM on the remote control. The Program mode display appears on the TV screen and the front panel display.

3Use the numeric keypad (0 ~ 9) to input the track numbers in the order you want, then press ENTER to confirm.

4To begin program playback, press

PLAY/PAUSE or ENTER.

5To stop playback, press STOP once.

6To cancel the program, press STOP twice.

Notes

•This function is available when playing CDs.

•This function is not available in pre-Stop mode.

•To repeat playback for the programmed tracks, press REPEAT while in the program playback mode.

•The program sequence is cancelled when you press STOP twice, open the disc tray, or turn the power off.

Accessing the Root menu

To access the Root menu:

•Press MENU during DVD playback. ROOT MENU appears on the screen, then the root menu opens.

Notes

•Depending on the DVD disc, you may not be able to select a title or chapter.

•Depending on the DVD disc, a “title menu” may be called a “menu” or “title” in the instructions supplied with the disc.

•For some DVD discs, when you press MENU, playback restarts from the beginning of the disc.

Activating Progressive Scan mode

The progressive scan display presents 60 complete frames per second, rather than 30 frames per second of interlaced scanning (normal TV). With nearly double the number of lines, progressive scan offers higher picture resolution and eliminates motion artifacts like jagged edges on moving objects. To enjoy the full quality potential offered by progressive scan, a progressive scan TV is required.

To activate progressive scan:

1In Stop mode, press P-SCANon the remote control to enter Progressive mode.

2In Stop mode, press P-SCANagain to enter Interlaced TV mode.

Note

To activate this function, you must set Video Output to Y Pb Pr and make sure that your TV has progressive scan.

Selecting Surround Sound

To turn on surround sound:

•Press the SURROUND button to select: Playing a DVD disc

•For a DVD disc with a Dolby Digital signal, you can select: Stereo or Dolby Digital

•For a DVD disc with a DTS 5.1 signal, you can select: Stereo or DTS*.

* Note

This receiver does not support DTS. If you select DTS mode, no sound is produced and the message “Press Language to select another audio track” is displayed on the TV screen.

•For a DVD disc with a PCM or Pro Logic signal, you can select: Pro Logic or Stereo.

•Playing a CD or MP3 disc or in AUX mode, you can select: Pro Logic or Stereo.

Note

The availability of various surround sound modes depends on the number of speakers connected and the sound mode available for the disc.

Selecting a sound effect

To select a sound effect:

•Press the EQ button repeatedly to cycle through the available preset equalizer modes, including: FLAT, JAZZ, ROCK, or POP.

To adjust individual speakers

You can vary the sound level of each speaker, as well as adjust the treble or bass levels.

To adjust individual speakers:

1Press LEVEL to review or adjust each speaker’s output level. The volume level of the channel appears on the front panel display and the TV screen.

•You can adjust the Front left, Center, Front right, Rear left, Rear right, and Subwoofer in 1dB steps from -10 dB to +10 dB.

•You can adjust the Master volume in 1 dB steps from 00 to +40 dB (maximum).

2Press VOLUME - and VOLUME + to adjust the selected channel’s level.

3If you do not press the LEVEL or VOLUME - /+buttons for a few seconds, the display is turned off, and the volume level is stored in the system.

Note

When you switch the power to STANDBY, then back ON, the volume level returns to 8 dB.

14

www.insignia-products.com