Insignia
To connect your headphones: | Use the remote control within about 23 feet |
• Insert the headphone plug into the headphone | (7 meters) of the receiver and within 30 degrees of |
jack on the receiver. | perpendicular to the front of the receiver. |
Note
To hear sound from the headphones, make sure the SPEAKER A and SPEAKER B buttons on the remote control or the Speaker A/B button on the receiver are set to off.
Connecting the power
To connect your receiver to power:
• Plug the power cord into an AC outlet.
Installing batteries
Caution
Do not use
Remove the batteries if they are not to be used for an extended period of time.
Cautions
•Do not expose the remote control to shock. In addition, do not expose the remote control to liquids, and do not place in an area with high humidity.
•Do not place the remote control under direct sunlight. The heat may cause deformation of the remote control.
•The remote control may not work properly if the remote sensor window of the receiver is under direct sunlight or strong lighting. In such a case, change the angle of the lighting or receiver, or operate the remote control closer to the remote sensor window.
Using your receiver
Tips
To install the batteries:
1Remove the cover.
2Insert two AAA batteries into the compartment matching the polarity indicated.
3Replace the cover.
The following settings are stored in memory before the receiver is turned off:
•INPUT SELECTOR settings
•Preset stations.
If the electricity fails or the AC power cord is unplugged for more than a week, your memory is cleared.
Listening to your receiver
To listen to your receiver:
1 Press the POWER button on the receiver to put the receiver in Standby mode. The STANDBY indicator lights blue.
2Press the POWER ON button on the remote control or the ON/STANDBY button on the receiver to turn the receiver on.
Using the remote control
Use the remote control by pointing it towards the receiver’s remote sensor window. Objects between the remote control and sensor window may prevent proper operation.
23’ (7m)
OR
Tip
You can put the receiver in Standby mode by pressing the STANDBY button on the remote control when the receiver is on.
With the receiver in Standby mode, you can also turn the power on by pressing an Input Selector button on the remote control.
www.insigniaproducts.com | 5 |