Rocketboost™ Wireless Subwoofer

Connecting your subwoofer for wireless mode

Important

Every Rocketboost network must contain one hub device, which helps devices join the network. The network can have only one hub, which you can enable using the hub switch on the back of all Rocketboost senders and wireless sender/receivers.

The wireless subwoofer is a Rocketboost wireless receiver and is not a hub device. To add this wireless receiver to your Rocketboost network, you need to join it to your hub device. This section describes the joining process.

Important

Hub devices must always have power for your network to operate. The hub device can be in standby (power saving) mode, but must stay plugged in.

Note

Rocketboost devices have their own memory. After the devices are joined once, they remember each other and join automatically when your devices are powered on again. Because of this, you can join all of your network components in the same room before installing them in their permanent locations throughout the house.

To establish communications:

1Press the Power button on the Rocketboost hub device to turn it on.

2Make sure that the INPUT SELECT switch on the subwoofer is set to

Wireless.

3Make sure that the power switch on your subwoofer is turned on. If the power indicator is red (Standby mode), briefly press the CONNECT button to turn on your subwoofer (the power indicator turns blue).

4Press and hold the Power button on the Rocketboost hub device for more than three seconds to put it into joining mode. The power indicator starts blinking rapidly and the unit will stay in joining mode for 30 seconds.

5Press and hold the CONNECT button on your subwoofer for more than three seconds to put it into joining mode.

•When successfully joined, the power indicators on both products will stop blinking and stay on.

•If joining fails after 30 seconds, the power indicators will begin flashing at a slower rate. If this occurs, repeat the above steps.

www.insigniaproducts.com11