Integra DPS-6.5 instruction manual Controlling AV Components that are Out of Range

Connecting the DPS-6.5—Continued

Controlling AV Components that are Out of Range

You can use the following multi-room kits to control the DPS-6.5 when it’s out of range of the remote controller:

•Onkyo Multi-Room System (IR Remote Controller Extension System)

•Multiroom AV distribution and control systems such as those made by Niles® and Xantech®.

IR

IN

OUT

VIDEO OUTPUT IR

					VIDEO	REMOTE	IN
						CONTROL
	COMPONENT 2			COMPONENT 1			AC INLET
Y	PB	PR	Y	PB	PR		RS232
					S VIDEO		OUT

Controlling Other Out-of-range AV Components

If another AV component is out of range of its remote controller, you can use a commercially available IR emitter to retransmit the remote controller signals received at the DPS-6.5’s IR IN, as shown below.

	Connecting	IR receiver
	block
IR IN
IR OUT	DPS-6.5
	IR emitter
	Remote controller
	Other
	component

Controlling the DPS-6.5 When It’s Out of Range : Signal flow

If the DPS-6.5 is located in another room, installed in a cabinet, or out of range of its remote controller, you can use a commercially available IR receiver to pickup the remote controller signals and feed them to the DPS-6.5, as shown below.

Connect the IR emitter to the DPS-6.5’s IR OUT, and place the IR emitter in front of the other AV component’s remote control sensor (usually located on its front panel), as shown below. See the instructions supplied with the IR emitter.

IR IN

DPS-6.5

Connecting block

IR receiver

	Other component
	Remote control
from connecting block	sensor
	IR emitter
Miniplug cable

Inside cabinet

Remote controller

	Miniplug
IR
IN

: Signal flow

Connect the IR receiver to the DPS-6.5 as shown below.

from connecting block

Miniplug cable

IR

IN

OUT

DPS-6.5

OUT	IR Emitter
DPS-6.5
	:Signal flow

Only remote controller signals received by the DPS- 6.5’s IR IN are fed through to the IR OUT. Signals picked up by the DPS-6.5’s remote control sensor are not output.

22