Integra DTR-5.1 appendix Selecting a sound source, Dvd

Selecting a sound source

Follow the steps below to select a device to play the sound source.

2.Make sure that the Speakers A indicator is lit on the display. If it is not lit, press the Speakers A button.

(Refer to the “Speakers selector” section on the page 20 for more details.)

Dimmer button

Use this button to change the brightness of the display (normal or dim).

4.Listening Mode Select a Listening mode. (Refer to page 22)

5.Adjust the volume to an appropriate level. These controls allow you to adjust the volume of the Front, Center, Surround speakers and subwoofer simultaneously. Turning the control clockwise increases the volume level. Turning the control counter- clockwise decreases the volume level. (Refer to page 20 for more details.)

Standby/On
Standby
Power
On	Off
Speakers
A	B
Phones

Dimmer Memory FM Mode Down Tuning Up

						Listening Mode		DSP
				Stereo	/DTS	5 CH Stereo
Display
					Surround
					Video 3		Tape	FM
				Video 2
Multi CH	DVD	Video	1
		VCR
Input

Digital/	SP/SYS
Analog	Setup	CH Level
	Mode
Preset/Mode ADJ
Down		Up
	Enter
Late Night/	Re-EQ	LFE Level
Front Effect		Control
AM	Phono	CD

Master Volume

Bass Treble

DTR5.1

1.Press the desired input selector button or Multi CH Input button.

The selected source name appears on the display. If you have selected DVD, CD, Video 1, Video 2, Video 3, or Tape, see page 18. Refer to page 19 for more information on Multi CH Input.

3.Start playing the selected input source.

Follow the operating instructions for the source device.

6.Use the bass, treble controls to adjust the tone. (Refer to page 20 for more details.)

1. Press the MODE AUDIO button

5. VOLUME button (qup/udown) Use this button to adjust the volume level.

2. SP A button Use this button

to select Speaker A.

HOME	THEATER
	RC-	CONTROLLER
	424M

SLEEP button

This button allows you to set the sleep timer. (Refer to page 20 for more details.)

MUTING button

This button mutes the sound temporarily.

(Refer to page 20 for more details.)

DIMMER button

Use this button to change the brightness of the display (normal or dim).

3. INPUT SELECTOR button

Use this button to select a desired sound source. (V4 button is not used for this DTR5.1.)

4. Select a Listening mode. (Refer to page 22)

Warning:

•Do not play CD-ROM discs that contain computer data as they may damage the speakers when the sound is amplified by the receiver.

Note:

If you hear no sound from the speakers, check the following items:

•Make sure that all devices and speakers are connected correctly and securely.

•The sound is muted when the “MUTING” is on the display. Press the MUTING button on the remote controller to cancel the mute function.

•When you select a source that is connected to the DIGITAL INPUT jacks on the rear panel. Check to see if the audio (digital or analog) selection is correct (when DVD, CD, Video 1-3, or Tape is selected) (refer to page 18).

•If you have selected Multi CH Input, you need to adjust the level of each speaker (refer to page 19).

17