Integra DTR-5.1 appendix Selecting a sound source, Selecting the input signal format

Selecting a sound source

		DTR5.1
	DVD Player	DIGITAL INPUT
		COAXIAL 2
		COAXIAL 1
		OPTICAL 2
		OPTICAL 1
1
DVD
2
Digital/
Analog
3
Preset/Mode ADJ
Down	Up
4
Enter
5
Preset/Mode ADJ
Down	Up
6
Enter
18

Assigning the digital input/Selecting the input signal format

Assigning the digital input

If another device is connected to the digital input jack of the DTR-5.1, assign the digital input to DVD, CD, VIDEO 1, VIDEO 2, VIDEO 3, or TAPE depending on the type of connected device. Follow the steps (1–4) below.

Note:

The default setting is “ANALOG.” In this case, you can- not play any digital signals from the digital input jacks (Dolby digital, DTS, etc.).

OPT1 — The DTR-5.1 plays back a digital signal input from the OPTICAL 1 jack.

OPT2 — The DTR-5.1 plays back a digital signal input from the OPTICAL 2 jack.

COAX1 — The DTR-5.1 plays back a digital signal input from the COAX 1 jack.

COAX2 — The DTR-5.1 plays back a digital signal input from the COAX 2 jack.

ANALOG — The DTR-5.1 plays back an analog signal input from the ANALOG input jack. (Digital signals input from the digital input jacks will not be played.)

Selecting the input signal format

Normally, select AUTO for this parameter. You can also select DIGITAL or ANALOG depending on the source. Follow the steps (4–6) below to change the setting.

AUTO (digital signal/analog signal playback mode) Digital signals have priority for playback. If no digital sig- nals are input, the DTR-5.1 plays back analog signals. When the DTR-5.1 plays back digital signals, it automati- cally detects the signal format (Dolby Digital, DTS, or PCM) and performs the necessary decoding process. DIGITAL (digital signal playback mode)

The DTR-5.1 plays back digital signals. (Input analog sig- nals will be ignored.)

The DTR-5.1 automatically detects the signal format (Dolby Digital, DTS, or PCM) and performs the necessary decoding process.

ANALOG (analog signal playback mode)

The DTR-5.1 plays back analog signals. (Input digital sig- nals will be ignored.)

Assume that you have connected a DVD player to the COAXIAL 1 connector.

1.Use the INPUT button to select “DVD.”

2.Press the Digital/Analog button to set digital input. “DGTL/ANLG SETUP” appears, followed by the cur- rent setting (OPT1, OPT2, COAX1, COAX2, or ANA- LOG).

3.Press “Preset/Mode ADJ Ã/¨” to select COAX1.

4.Press the Enter button.

The unit displays “INPUT FORMAT” in a few seconds, followed by the current setting (AUTO, DIGITAL, or ANALOG).

5.Press “Preset/Mode ADJ Ã/¨” to select AUTO, DIGI- TAL or ANALOG.

6.Press the Enter button.

Tip:

You may play analog audio while digital input is selected if you select “ANALOG” in Step 5.

Note:

•You cannot select “INPUT FORMAT” as described in Step 4 if you select “ANALOG” in Step 3.

•You can assign digital input to DVD, VIDEO 1, VIDEO 2, VIDEO 3, TAPE, and CD.