Specifications
Amplifier Section
Rated Output Power (FTC)
Front L/R: | 50 watts minimum continuous power |
| per channel, 8 ohm loads, 2 channels |
| driven at 1 kHz, with a maximum total |
| harmonic distortion of 0.05% |
THD (Total Harmonic | 0.05% (Power Rated) |
Distortion) | 0.05% (1kHz, 1W) |
Damping Factor | 60 |
Input Sensitivity and |
|
Impedance | 720 mV/22 kΩ (Unbalanced) |
Preamplifier Output |
|
Level and Impedance |
|
( Z1 - Z4 L/R) | +16 dB / 680 Ω |
Frequency Response | 20 Hz - 50 kHz/0 dB - 3 dB |
Tone Control | ±10 dB, 100 Hz (BASS) |
| ±10 dB, 10 kHz (TREBLE) |
Signal to Noise Ratio | 95 dB (S1, |
Speaker Impedance | 6 Ω - 16 Ω |
General
Power Supply | AC 120 V, 60 Hz |
Power Consumption | 4.0 A |
Standby Power |
|
Consumption | 21.4 W |
Dimensions |
|
(W ⋅ H ⋅ D) | |
Weight | 27.8 lbs. |
■ Video Inputs |
|
Composite | S1 - S8 |
■Video Outputs
CompositeZ1 - Z4
■Audio Inputs
Analog Inputs | S1 - S8 |
Video Section
Input Level & Impedance |
|
(S1 - S8) | 1 |
Buffered Video Output |
|
Level and Impedance (S1 |
|
- S8) | 1 |
Output Level & |
|
Impedance (Z1 - Z4) | 1 |
■Audio Outputs
Zone Pre Output | Z1 | - Z4 |
Speaker Outputs | Z1 | - Z4 (L/R) |
■ Interface
IR Output | A, B, IR1, IR2 - 3.5mm phone Jack |
Expansion Bus | Input & Output - 34 way 0.1" Double Row |
| Header |
12V DC 1 Amp Power | Two DC power sockets, Center positive |
| (2.1mm pin diameter) |
RS232 | One DB9 - 9600 Baud |
USB | One : USB |
Controller | Two: 4 way terminal blocks (0V, IR, 12V |
| & Data) |
Amp On Control | One: 7 way terminal plug with Amp ON 1 |
| - 4 and # |
| One Page Preset Contact closure Input - |
| PG |
Specifications and features are subject to change without notice.
Integra Division of
ONKYO U.S.A. CORPORATION
18 park Way, Upper Saddle River, N.J. 07458, U.S.A.
Tel:
Integra Division of
ONKYO CORPORATION
Sales & Product Planning Div.:
Tel: 072-831-8023 Fax: 072-831-8124
En
SN 29344365A
(C) Copyright 2006 ONKYO CORPORATION Japan. All rights reserved. | * 2 9 3 4 4 3 6 5 A * |
28 |
