ST2 TUNER PROGRAMMING
ST2 TUNER SETUP MENU
Press and Hold TNR SEL button
ST2 Chassis Setup Procedures
TNR TNR
SEL SEL
TUNER | SOURCE | UPDATE | FACTORY | SYSTEM | Chassis | |
SETUP | NUM | FIRMW | INIT |
| INFO | Setup |
Menu | Procedure | Procedure | Procedure | Procedure | Menu | |
|
| |||||
| TNR |
|
|
|
|
|
| SEL |
|
|
|
|
|
|
|
| This |
|
|
|
| TUNER | HOLD | Procedure |
|
| |
| # | BAND | returns the |
|
| |
|
|
| ST2 Tuner |
|
| |
|
|
| to its |
|
|
|
|
|
| Factory |
|
| |
|
|
| settings |
|
| |
|
| After update |
|
|
|
|
|
| cycle Power |
|
|
|
|
| SOURCE |
| Are you sure |
|
| |
| NUM | Start |
|
|
|
|
|
|
|
|
|
| |
|
| Update |
|
|
|
|
|
|
| YES | NO |
|
|
|
| Cycle Power | Please wait |
|
| |
|
|
|
|
| ||
|
|
| Cycle Power |
|
| |
Update Firmware (Chassis) (cont’d)
4.“Hold BAND” appears on the tuner.
5.While pressing and holding BAND, “After update cycle power” appears on the tuner display.
6.When “Start Update” appears on the tuner dis- play, start the update program. “Finished” appears on the computer screen when complete.
7.Cycle power to the tuner.
Factory Initialization (Chassis)
The Factory Initialization procedure allows the erasure of all programmed settings and returns them to the factory default settings.
1.Enter the Setup Menu by pressing and holding the TNR SEL button.
2.TUNER SETUP appears. Press MEM Up/Down until FACTORY INIT appears on the tuner.
3.Press BAND to enter the FACTORY INIT menu.
4.“Are you sure” appears on the tuner. Using the Tune Up/Down buttons, view the “Yes” and “No” selections.
5.Press BAND to select. A “No” selection
returns to the top of the Factory Init menu. A “Yes” begins the initialization.
6.“Please wait” appears on the tuner during the process and “Cycle Power” appears when com- plete.
7.Cycle power on the ST2 tuner.
22
