Onboard LAN Boot ROM, Onboard Serial Port | Intel 4127, 4112

Onboard LAN Boot ROM

Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip. (Default: Disabled)

Onboard Serial Port 1

Enables or disables the first serial port and specifies its base I/O address and corresponding interrupt. Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.

Onboard Parallel Port

Enables or disables the onboard parallel port (LPT) and specifies its base I/O address and corresponding interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.

Parallel Port Mode

Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel Port)(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.

ECP Mode Use DMA

Selects DMA channel for the LPT port in ECP mode. This item is configurable only if Parallel Port Mode is set to ECP or ECP+EPP mode. Options are: 3 (default), 1.

GA-945GCM-S2L/S2C Motherboard

- 42 -

Image 42

Intel 4127, 4112 Onboard LAN Boot ROM, Onboard Serial Port, Onboard Parallel Port, Parallel Port Mode, ECP Mode Use DMA

Contents

GA-945GCM-S2L/ GA-945GCM-S2C Motherboard Documentation Classifications CopyrightDisclaimer Identifying Your Motherboard Revision Table of Contents Regulatory Statements Box Contents GA-945GCM-S2L/GA-945GCM-S2C Motherboard Layout Block Diagram Hardware Installation Installation Precautions Product Specifications CPU 4 Mbit flash Page Installing the CPU and CPU Cooler Installing the CPU CPU Socket Lever Installing the CPU Cooler Installing the Memory Dual Channel Memory Configuration Installing a Memory Installing an Expansion Card Back Panel Connectors Line In Jack Blue Line Out Jack GreenMic In Jack Pink Internal Connectors Pwrled GND FDD Floppy Disk Drive Connector CPUFAN/SYSFAN Fan Headers IDE IDE Connector SATAII0/1/2/3 Sata 3Gb/s Connectors, Controlled by ICH7 Pwrled System Power LED Header Batbattery Fpanel Front Panel Header Cdin CD In Connector Faudio Front Panel Audio Header Spdifo S/PDIF Out Header FUSB1/FUSB2 USB Headers Clrcmos Clearing Cmos Jumper CI Chassis Intrusion Header GA-945GCM-S2L/S2C Motherboard Bios Setup Following screen may appear when the computer boots Startup Screen Sample Bios Version GA-945GCM-S2L E10 Bios Setup Program Function KeysMain Menu „ Power Management Setup „ Standard Cmos Features„ Advanced Bios Features „ PnP/PCI Configurations IDE Channel 0 Master/Slave DateTime IDE Channel 2, 3 Master/Slave Halt on Floppy 3 Mode SupportDrive a Memory Password Check Hard Disk Boot PriorityFirst/Second/Third Boot Device HDD S.M.A.R.T. Capability CPU Enhanced Halt C1ENote Limit Cpuid Max. to 3 NoteNo-Execute Memory Protect Note CPU Thermal Monitor 2 TM2 Note Pata IDE Set to On-Chip Sata ModeOn-Chip Primary PCI IDE Sata Port 0/2 Set to USB 2.0 Controller Sata Port 1/3 Set toUSB Controller USB Keyboard Support Smart LAN LAN Cable Diagnostic Function Smart LAN ECP Mode Use DMA Onboard LAN Boot ROMParallel Port Mode Onboard Serial Port Power On by Ring Soft-Off by PWR-BTTNPME Event Wake Up Power On By Mouse Resume by AlarmHpet Mode Note Power On By Keyboard PnP/PCI Configurations PCI1 IRQ AssignmentPCI2 IRQ Assignment CPU Warning Temperature Reset Case Open StatusCurrent CPU Temperature Case Opened CPU Smart FAN Control CPU Clock Ratio Note FSB1333 Core 2 CPUCPU Host Clock Control System Memory Multiplier CPU Host Frequency MhzPCI Express Frequency Mhz Memory Frequency Mhz Load Fail-Safe Defaults Load Optimized Defaults Set Supervisor/User Password Save & Exit Setup Exit Without Saving Drivers Installation Installing Chipset Drivers Software Applications Driver CD Information Hardware Information Contact Us GA-945GCM-S2L/S2C Motherboard Xpress Recovery2 Before You BeginSystem Requirements Installation and Configuration Installing Windows XP and Partitioning the Hard DrivePage Accessing Xpress Recovery2 Using the Backup Function in Xpress Recovery2 Using the Restore Function in Xpress Recovery2 Removing the BackupExiting Xpress Recovery2 Bios Update Utilities Updating the Bios with the Q-Flash Utility Updating the Bios Press Y to load Bios defaults Updating the Bios with the @BIOS Utility Installing and Using @BIOSOptions and Instructions Update the Bios without Using the Internet Update Function EasyTune EasyTune 5 Interface Button Information Table Windows Vista ReadyBoost Configuring Audio Input and Output Configuring 2/4/5.1-Channel AudioConfiguring Speakers Speakers or Headphones Configuring Sound Effect Activating an AC97 Front Panel Audio ModuleMuting the Back Panel Audio For HD Audio Only Installing the S/PDIFOut Cable Optional Installing the S/PDIF Out CablePdif out Configuring S/PDIF out Configuring Microphone Recording Appendix Using the Sound Recorder Recording the SoundPlaying the Sound Troubleshooting Frequently Asked Questions Troubleshooting Procedure Start END Weee Symbol Statement Regulatory NoticesOur Commitment to Preserving the Environment China Restriction of Hazardous Substances Table GA-945GCM-S2L/S2C Motherboard Contact Us B.T. INC USA Mexico Gigabyte Global Service System