Intel 8S661FXM-RZ , ,

- 30 -8S661FXM-RZ Motherboard

English

System after AC Back

Off When AC-power back to the system, the system will be in "Off" state.

(Default Value)

OnWhen AC-power back to the system, the system will be in "On" state.

LastStateWhen AC-power back to the system, the system will return to the Last state

before AC-power off.

IRQ [3-7, 9-15], NMI

Disabled Disable this function.

Enabled Enable this function. (Default value)

ModemRingOn

Disabled Disable Modem Ring on function.

Enabled Enable Modem Ring on function. (Default Value)

PME Event Wake Up

Disabled Disable this function.

Enabled Enable PME Event Wake up. (Default Value)

Power On by Keyboard

Any KeySet Keyboard power on by any key.

PasswordInput password (from 1 to 8 characters) and press Enter to set the Keyboard

Power On Password.

Disabled Disable this function. (Default Value)

Power On by Mouse

Enabled Enable Power On by Mouse function.

Disabled Disable this function. (Default Value)

Resume by Alarm

You can enable Resume by Alarm and key in month/date/time to turn on system.

Disabled Disable this function. (Default Value)

Enabled Enable alarm function to POWER ON system.

If RTC Alarm Lead To Power On is Enabled.

Month Alarm :NA, 1~12

Day (of Month) :0~31

Time ( hh: mm: ss) :(0~23) : (0~59) : (0~59)

Contents

Main 8S661FXM-RZ User's Manual Intel Pentium 4 Processor Motherboard Rev. 1101 12ME-S661FXMRZ-1101 Page Preparing Your Computer Installing the motherboard to the chassis Table of Content Chapter 1 Introduction Features Summary Page 8S661FXM-RZ Introduction- 7 - "*" Only for 8S661FXM-RZ Rev. 1.1 8S661FXM-RZ Motherboard Layout Block Diagram Hardware Installation Process Step 2 Step 1 Step 3 Step 1: Install the Central Processing Unit (CPU) Step 1-1: CPU Installation Step 1-2: CPU Cooling Fan Installation Step 2: Install memory modules Step 3: Install expansion cards Step 4: Install I/O Peripherals Cables Step 4-1: I/O Back Panel Introduction Step 4-2: Connectors Introduction - 14 - 8S661FXM-RZ Motherboard 1) ATX_12V (+12V Power Connector) Pin No. Definition 1 GND 2 GND 3 +12V 4 +12V 2) ATX (ATX Power) 3) CPU_FAN (CPU FAN Connector) Pin No. Definition 1 GND 2 +12V 3 Sense 4) SYS_FAN (System FAN Connector) 5) FDD (Floppy Connector) 6) IDE1/ IDE2(IDE1/IDE2 Connector) - 16 - 8S661FXM-RZ Motherboard 7) F_PANEL (2x10 pins connector) 8 ) PWR_LED 9) BAT (Battery) CAUTION + 10)F_AUDIO (F_AUDIO Connector) 10 9 11)CD_IN 12) SPDIF_IO (SPDIF In/Out) 13)SUR_CEN 14)F_ USB1 / F_USB2 (Front USB Connector) 15)CLR_CMOS (Clear CMOS) 16)COMB (COM B Connector) 17)CI (Chassis Intrusion, Case Open) * Chapter 2BIOS Setup CONTROL KEYS ENTERING BIOS Setup Main Menu Status Page Setup Menu / Option Page Setup Menu Page Standard CMOS Features Date Time IDE Primary Master, Slave / IDE Secondary Master, Slave Drive A / Drive B Floppy 3 Mode Support (for Japan Area) Halt on Memory Base Memory Advanced BIOS Features First / Second / Third Boot Device Boot Up Floppy Seek Page Integrated Peripherals IDE1 Conductor Cable On-Chip Primary PCI IDE On-Chip Secondary PCI IDE Page Power Management Setup ACPI Suspend Type Soft-off by PWR_BTTN PnP/PCI Configurations PCI 1 IRQ Assignment PCI 2 IRQ Assignment PCI 3 IRQ Assignment PC Health Status Reset Case Open Status * Case Opened * Current Voltage (V) VCORE / +3.3V / DDR2.5V / +12V MB Intelligent Tweaker (M.I.T.) Configure DRAM Timing CAS Latency Setting DRAM RAS Active Time DRAM RAS Precharge Time Top Performance AGP/PCI Clock Control - 35 -BIOS Setup Load Fail-Safe Defaults Set Supervisor/User Password Load Optimized Defaults Exit Without Saving Save & Exit Setup Revision History Chapter 3Install Drivers INSTALL CHIPSET DRIVER Pictures below are shown in Windows XP Install Drivers Item Description Page CONTACT US Contact us via the information in this page all over the world. - 40 -8S661FXM-RZ Motherboard