INTRODUCTION
Installing the Memory
The ET900 COM Express CPU module accommodates
Installing and Removing Memory Modules
To install the DDR2 modules, locate the memory slot on the board and perform the following steps:
1.Hold the DDR2 module so that the key of the DDR2 module align with those on the memory slot. Insert the module into the socket at a slight angle (approximately 30 degrees). Note that the socket and module are both keyed, which means that the module can be installed only in one direction.
2.To seat the memory module into the socket, apply firm and even pressure to each end of the module until you feel it slip down into the socket.
3.With the module properly seated in the socket, rotate the module downward. Continue pressing downward until the clips at each end lock into position.
4.To remove the DDR2 module, press the clips with both hands.
6 | ET900 User’s Manual |
