Intel FSB800 (PC3200), FSB800 (PC2700) I/O Shield Connector, Power-On/OffRemote, Introduction

Introduction

I/O Shield Connector

The board is equipped with an I/O back panel (Figure 3). Ensure that your computer

case has the appropriate I/O cutout.

	RJ-45 LAN
Parallel Port	(Optional)	Line-in/Rear out (Blue)
PS/2
Mouse		Line-out/Front out (Green)
PS/2		Mic-in/Center&Subwoofer (Pink)
Keyboard
COM1	USB2.0 USB2.0
	ports ports

Figure 3: I/O ports

Power-On/Off (Remote)

The board has 20-pin ATX and 4-pin ATX12V connectors for power supplies (Figure 4). For power supplies that support the Remote On/Off feature, this should be connected to the mainboard front panel PW_ON connector for the computer power On/Off button.

The board has been designed with “Soft Off" function. You can turn off the system two ways: pressing the front panel power On/Off button, using the "Soft Off" function (incorporated in the mainboard’s onboard circuit controller) that can be controlled by an operating system such as Windows®XP/ME/2000/98/95.

Note: For maintaining the DDR SDRAM power during STR (ACPI S3) function, it is strongly recommend to use power supplies that have a +5VSB current of (>=) 2A. Please check the 5VSB’s specification that has been printed on the power supply’s outer case.

Note: The board requires a minimum of 250 Watt power supply to operate. Your system configuration (amount of memory, add-in cards, peripherals, etc.) may exceed the minimum power requirement but to ensure that adequate power is provided, use a 300 Watt (or greater) power supply.

12V 4-pin

POWER SUPPLY 20-pin

PW-ON

Case (chassis) Power ON/OFF button (PW-ON)

Figure 4: Simple ATX power ON/OFF controller

Page 1-6