Intel FSB800 (PC2700) Installation, FDD IDE1/2 IDE3/4, Floppy Controller Connector Black, Page

Installation

IDE2 IDE1

IDE4 IDE3FDD

34 33 40 39

FDD:

IDE1/2:

IDE3/4:

(Optional)

Floppy Controller Connector (Black)

Ultra DMA-66/100 Primary/Secondary IDE Connector (Blue)

Ultra DMA-66/100 & RAID Primary/ Secondary IDE Connector (Red) Supported by HPT372 chipset, refer to HPT372 RAID Controller user’s manual for detail information.

2 1

FDD 2 1

IDE1/IDE2

PW1

PW12

			￿￿	￿
			+12V		+5V
			5VSB		+5V
!	"		PW-OK		-5V
+12V		+12V	Gronud		Gronud
			+5V		Gronud
Gronud		Gronud	Gronud		Gronud

￿+5V PS-ON

PW12	Gronud	Gronud
	3.3V	-12V
	3.3V	3.3V

￿ ￿￿

PW1

PW1: 20-pin ATX Power Connector

PW12: 4-pin ATX12V Power Connector

The mainboard is equipped with a standard 20-pin ATX main power connector and a 4-pin +12V power connector for connecting an ATX12V power supply. The plugs of the power cables are designed to fit in only one orientation. Find the proper orientation then insert the plugs into the connectors until they fit in place.

Caution:

Be sure that the PW1 and PW12 Power Connector must be used simultaneously or else can not boot-up.

!The board requires a minimum of 250 Watt power supply to operate. Your system configuration (amount of memory, add-in cards, peripherals, etc.) may exceed the minimum power requirement but to ensure that adequate power is provided, use a 300 Watt (or greater) power supply.

Page 3-12