Intel GA-945P-DS3/S3 user manual Integrated Peripherals, Smart LAN

English

2-3	Integrated Peripherals
		CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
			Integrated Peripherals
	On-Chip Primary PCI IDE		[Enabled]		Item Help
	On-Chip SATA Mode		[Auto]		Menu Level`
x	PATA IDE Set to		Ch.0 Master/Slave
	SATA Port 0/2 Set to		Ch.2 Master/Slave
	SATA Port 1/3 Set to		Ch.3 Master/Slave
	USB Controller		[Enabled]
	USB 2.0 Controller		[Enabled]
	USB Keyboard Support		[Disabled]
	USB Mouse Support		[Disabled]
	Legacy USB storage detect		[Enabled]
	Azalia Codec		[Auto]
	Onboard H/W LAN		[Enabled]
`	SMART LAN		[Press Enter]
	Onboard LAN Boot ROM		[Disabled]
	Onboard Serial Port 1		[3F8/IRQ4]
	Onboard Parallel Port		[378/IRQ7]
	Parallel Port Mode		[SPP]
x ECP Mode Use DMA			3
KLJI: Move		Enter: Select	+/-/PU/PD: Value	F10: Save	ESC: Exit	F1: General Help
	F5: Previous Values		F6: Fail-Safe Defaults		F7: Optimized Defaults
	On-Chip Primary PCI IDE
	Enabled		Enable onboard 1st channel IDE port. (Default value)
	Disabled		Disable onboard 1st channel IDE port.
	On-Chip SATA Mode
	Disabled		Disable this function.
	Auto		BIOS will auto detect. (Default value)
	Combined		Set On-Chip SATA mode to Combined, you can use up to 4 HDDs on
			the motherboard; 2 for SATA and the other 2 for PATA.
	Enhanced		Set On-Chip SATA mode to Enhanced, the motherboard allows up to 6
			HDDs to use; 4 SATA HDDs plus 2 PATA HDDs.
	Non-Combined		Set On-Chip SATA mode to Non-Combined, SATA will be simulated to
			PATA mode. Support a maximum of 4 SATA devices. PATA devices will be
			ignored.
	PATA IDE Set to
	Ch.1 Master/Slave		Set PATA IDE to Ch. 1 Master/Slave.
	Ch.0 Master/Slave		Set PATA IDE to Ch. 0 Master/Slave. (Default value)
	SATA Port 0/2 Set to
	This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
	If PATA IDE were set to Ch. 1 Master/Slave,this function will auto set to Ch. 0 Master/Slave.
	SATA Port 1/3 Set to
	This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
	If PATA IDE were set to Ch. 0 Master/Slave,this function will auto set to Ch. 1 Master/Slave.
	USB Controller
	Enabled		Enable USB Controller. (Default value)
	Disabled		Disable USB Controller.

GA-945P-DS3/S3 Motherboard - 36 -