Intel PX865PEL-800 Audio Connectors, CD-ROM Audio-InHeader CD-IN, Front Audio, Cd-In, Spdif

PX865PEL-800

Audio Connectors

This mainboard provides three connectors as part of its audio Subsystem.

MIC MIC_VREF Front out_R NC Front out_L

1 2

Ground

+5V

Rear out_R

NC

Rear out_L

FRONT AUDIO

Left In	1
Ground	2	21	BIOS	LAN CHIP	ALC 650
Ground	3				W83627HF	Winbond
Right In	4	1	1				1
CD-IN							82865P		S
+5V	1							Intel	ocket 478
NC	2	21
SPD_OUT	3	2 1		Intel ICH 5					1
Ground	4	910
SPD_IN	5	1	1
		1
SPDIF		1	2
			1	1
		9	10

CD-ROM Audio-In Header: CD-IN

This header is used to connect to a CD-ROM / DVD audio cable.

S/PDIF (Sony/Philips Digital Interface) Header: SPDIF

S/PDIF is a recent audio transfer file format, which provides high quality audio using optical fiber and digital signals. This mainboard is capable of delivering audio output and receiving audio input through the SPDIF header. One way you would use this header is by using an SPDIF bracket attached to your computer. This bracket will have a cable that you can attach to the SPDIF header. This bracket will also have an RCA connector, similar to that used with most consumer audio products. Using the RCA connector, the data can then be output to and input from an S/PDIF device. The devices that are receiving and sending information from this header must be S/PDIF compliant for optimal effect. Note that the SPDIF bracket is optional in the packaging that comes with this mainboard.

Front Panel Audio Header: FRONT AUDIO

If your computer case has been designed with embedded audio equipment. You can attach these components to the FRONT_AUDIO panel of the mainboard. First remove the jumper caps covering the FRONT_AUDIO pins. Use pins 1, 3 to connect to the case microphone. Use pins 9,5 to connect to the earphone. If you do not intend to use the FRONT_AUDIO panel, do not remove the jumper caps.

Attention

If the jumper caps are in place, jumper cap 1 is on pin 5, pin 6 and jumper cap2 is on pin 9, pin 10.

16