PX865PEL-800

Connectors

Floppy Disk Connector: FDC

This mainboard provides a standard floppy disk connector (FDC) that supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy diskettes. This connector supports the floppy drive ribbon cables provided in the packaging.

Hard Disk Connectors: IDE1-2/ SATA1-2

This mainboard has a 32-bit Enhanced PCI IDE Controller that supports PIO Mode 0~4, Bus Master, Ultra ATA 33/ 66/ 100. It has two IDE connectors, IDE1 (primary) and IDE2 (secondary). This mainboard also provides two serial ATA connectors that support serial ATA150.

IDE1 (Primary IDE Connector)

You can connect up to two hard drives to IDE1. If you attach two drives, you must use a ribbon cable with three connectors. You must also configure one drive as the master and one drive as the slave, using the jumpers located on each drive.

IDE2 (Secondary IDE Connector)

The IDE2 controller can also support a Master and a Slave drive. The configuration is similar to IDE1. The second drive on this controller must be set to slave mode.

SATA1/ SATA2

The SATA connectors support Serial ATA 150 and SATA RAID 0 mode. The connectors only can connect one serial ATA hard disk device each.

 

21

BIOS

LAN CHIP

ALC 65 0

 

 

 

 

 

1

 

W83627HF

Winbond

 

 

 

1

 

 

 

1

 

 

 

21

 

 

 

 

 

 

 

 

 

 

 

82865P

Intel

So cket 478

 

21

 

 

 

 

 

1

 

910

 

Intel ICH 5

 

 

 

 

 

1

1

 

 

 

 

 

FDC

1

 

 

 

 

 

1

2

 

 

 

 

 

 

 

 

1

 

 

 

 

 

9

10

 

 

 

 

 

SATA1 SATA2

IDE2 IDE1

13

Page 16
Image 16
Intel PX865PEL-800 warranty Floppy Disk Connector FDC, Hard Disk Connectors IDE1-2/ SATA1-2