Intel SBC-776 manual Hot Key Power On, Onboard FDC Controller, Uart Mode Select, RxD, TxD Active

Hot Key Power On

Simply pressing on the pre-selected keyboard key the system will power on.

Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install an add-in FDC or the system has no floppy drive, select Disabled in this field.

UART Mode Select

Select an operating mode for the second serial port:

Normal	RS-232C serial port
IrDA 1.0	Infrared port compliant with IrDA 1.0
	specification
IrDA SIR	IrDA-compliant serial infrared port
IrDA MIR	1 MB/sec infrared port
IrDA FIR	Fast infrared standard
ASK IR	Amplitude shift keyed infrared port
SCR

RxD, TxD Active

Consult your IR peripheral documention to select the correct

setting of the TxD and RxD signals

UR2 Duplex Mode

Select the value required by the IR device connected to the IR prot. Full-duplex mode permits simultaneous two-direction transmission. Half-duplex mode permits transmission in one direction only at a

time. If no infrared port is present in the system, select disabled.

Use IR Pins

Consult your IR peripheral documentation to select the correct setting of the TxD and RxD signals.

64SBC-776 User Manual