Intel SR6850HW4 8.5.3 System ID Buttons and LEDs, Revision, Intel order number D23151-001, Table 60. System ID LED Details, Front Panel I/O and Control Boards

Intel® Server Platform SR6850HW4 TPS				Front Panel I/O and Control Boards
			Amber, blinking	Non-Critical	Redundant power supply
				Alarm	or blower failure.
					Non-critical blower,
					voltage, or temperature
					failure.
	J, K	LAN1, LAN2 Status LEDs	Indicates LAN activity status
		(green)
			Off	Idle
			On	Inactive	No access
			Blinking	Active	Access
	L	Hard Drive Status LED	Indicates hard drive activity and fault status.
		(green/amber)
			Green	On	A hard drive is being
					initialized
			Green	Blinking	A hard drive is active
			Amber	On	Hard drive/slot failure
			Amber	Slow blinking	A predictive hard drive/slot
				(~1 Hz)	failure or rebuild in
					process
			Amber	Fast blinking	Hard drive rebuild
				(~2.5 Hz)	interrupted or rebuild on
					empty slot
	M	System Reset button	Resets the system

Figure 36. Local Control Panel Features

8.5.3 System ID Buttons and LEDs

The system contains two system ID buttons and two blue system ID LEDs. The LEDs are used to easily identify a platform. It is useful when several platforms are racked or installed near each other and a specific system needs to be serviced. One button/LED pair is located on the front control panel and a second button/LED pair is located at the rear of the platform.

The system ID LEDs can be turned on and off either by the system ID buttons or remotely through server management software. If the LEDs are activated by the system LED button, they must be turned off with the button; they cannot be turned off remotely through software. If the LEDs are activated through software, they must be turned off through software, not by pressing the system LED button.

	Table 60. System ID LED Details
LED State		Description
Off		System ID inactive.
On		System ID active via button.
Blinking		System ID active via remote command.

Revision 1.0	95
	Intel order number D23151-001