Extended IDE Drive | You can use one of two methods: |
Auto | Allows BIOS to automatically detect IDE devices during POST(default) |
None | Select this if no IDE devices are used and the system will skip the |
| automatic detection step and allow for faster system start up. |
Access Mode | Use this to set the access mode for the hard drive. The two |
| options are:Large/Auto(default:Auto) |
Hard drive information should be labeled on the outside drive casing. Enter the appropriate option based on this information.
nDrive A/B
Allows user to configure the type of floppy drive his/she installs.
Options:None (No floppy drive installed)
360K, 5.25" (5.25 inch
1.2M, 5.25" (5.25 inch
720K, 3.5" (3.5 inch
nFloppy 3 Mode Support
Allows user to configure a Japanese standard 3 Mode floppy drive.
Options:Disabled (No 3 Mode drive installed)
Drive A (3 Mode Drive installed in A:)
Drive B (3 Mode Drive installed in B:)
Both (3 Mode Drive installed in A: and B:)
nHalt on
Tells the BIOS specifically which types of errors will halt the computer during the power- on self test (POST) section of the boot.
Options:No Errors (Never halt when an error is detected) All Errors (Halt whenever an error is detected)
All, But Keyboard (Halt whenever an error is detected with the exception of the keyboard)
All, But Diskette (Halt whenever an error is detected with the ex ception of the diskette)
All, But Disk/Key (Halt whenever an error is detected with the exception of the diskette and keyboard) (default:All, But Keyboard)
nMemory
When BIOS is displayed during POST, memory capacity is also displayed as shown below:
Base Memory, Extended Memory, Total Memory (the user can verify the accuracy of these values)
English
19
