English
2.Hardware Installation
1.Please make sure that the CPU used is supported by your motherboard.
2.Please be aware of the placement position of the CPU. If the CPU does not insert properly, do not apply force but check the placement position.
3.Please make sure that an even layer of heat sink paste is added between the CPU and the fan sink.
4.Please do not turn on the power prior to installing the fan sink. Doing so can result in overheating and lead to permanent damage to the CPU.
5.Please follow the CPU specifications when setting the frequency. It is not recommended that system speed settings exceed that of hardware specifications. If you wish to set your system speed to exceed the recom mended specifications, please check your hardware specifications eg: CPU, graphics card, memory, hard drive
The following must be supported to allow the use of
-an Intel Pentium 4 CPU with HT
-a motherboard supporting HT
-HT selection feature within BIOS
-an operating system supporting HT
2.1.Installation of a LGA775 Pentium 4 CPU and Fan Sink
2.1.1.Installation of a LGA775 CPU
1. Push the socket lever arm down and away from the CPU socket and raise it up completely.
2. Open the load plate and gently remove the plastic cover.
3.Hold the CPU with your thumb and index fingers (do not touch the bottom of the CPU when holding it).
Align notchs on the two sides of the CPU with the small sockets of the CPU socket and place the CPU straight down.
10
