•Direct Link Setup Enable: Click the check box to enable, then click
“Apply” to further configure the function (all within the Direct Link panel).
-MAC Address: Specify the MAC address of the client adapter you want to direct link to and click “Apply” to add to the DLS Status table (below).
-Timeout Value: Specify the timeout value for the direct link being set up.
about
On this screen, you can click the hyperlink for information on the wireless chipset manufacturer. Basic information about the utility (driver, EEPROM version, etc.) also displays, as do various addresses for quick reference.
NOTE: This adapter features Turbo Mode, which delivers a higher throughput than IEEE 802.11g standard (up to 54 Mbps) by compressing data and decreasing the wait time for sending data to routers or access points. Turbo Mode is enabled automatically without any configuration.
wps configuration
The adapter supports WPS
WPS AP List: Wireless access points offering WPS service are shown
