Inter-Tel 831.10507 user manual Set-Up And Assembly, One 1 phillips screwdriver

SET-UP AND ASSEMBLY

Before beginning assembly, carefully read the following information and instructions:

•Place all parts in a cleared area and remove the packing materials from the spa shell; do not dis- pose of the packing materials until assembly is completed and the spa is in operation.

•Assembly requires two people.

•During assembly, make sure that all parts are ori- ented as shown in the drawings.

•Read each assembly step before you begin.

•Tighten all parts as you assemble them, unless instructed to do otherwise.

ASSEMBLY REQUIRES THE FOLLOWING TOOLS (NOT INCLUDED):

•One (1) phillips screwdriver

•You may also need a small amount of soap or wax.

1.Before beginning assembly, make sure that you have read and understand the information on the previous two pages.

To remove the access cover, insert fingers into the finger holes and pull it away from the Spa Unit (15).

Be careful not to damage the spa shell as you remove the cover.

2.Locate and check the positions of the two cut-off valves. The cut-off valves may have been closed at the factory during manufacturing. However, the cut-

off valves must be open when the spa is operated. To open the valves, turn the handles and pull them

out to the open position. IMPORTANT: THE

MOTOR WILL BE DAMAGED IF IT IS OPERATED WITH THE CUT-OFF VALVES CLOSED.

Next, close the valve knob on the drain hose. Thread the cap onto the drain hose. Thread the drain plug into the Pump Motor (13). Tighten the pump fittings.

1		Spa
		Shell
			15
		Access
		Cover
2			Cut-off Valve
Cut-off
	Valve
			13
			Drain Hose
Cap	Valve	Drain	Pump
	Knob	Plug	Fittings

8