ADJUSTING THE FILTER CYCLE
The spa filter cycle runs automatically to clean the water in the spa. However, the number of times that the filter cycle needs to run depends on how often the
SECURING THE SPA COVER
To secure the spa, snap the latches on the spa cover into the buckles on the side panels.
spa is used. If the spa is used regularly by several people, the water will need to be filtered more often than if it is used only occasionally by a few. The num- ber of daily cycles, as well as the length of the cycle, can be adjusted.
The pump can run one to three filter cycles daily. To change the number of cycles, press the pump and up buttons at the same time (refer to the console dia- gram on page 13). The number of cycles will appear in the temperature display. Press the up and down buttons to select the desired number of cycles.
To lock the buckles, insert the key and turn it clockwise 1/4 turn. To unlock the buckles, insert the key and turn it counterclockwise 1/4 turn. Always keep the buckles locked when
the spa is not in use. Keep the keys in a
safe place, out of the reach of children.
Latch
Buckle
Key
ATTACHING THE RED AND BLUE LIGHT COVERS
Each cycle can run for 60, 120, or 180 minutes. To change the length of the cycle, press the light and up buttons at the same time. The length of the cycle will appear in the temperature display. Press the up and
down buttons to select the desired cycle length.
Note: The pump or the light may turn on while you are adjusting the filter cycle. If this happens, you can turn the pump or the light off once you have finished the adjustment procedure.
The spa includes red and blue light covers for the spa light. To attach one of the light covers, hold the cover over the light and press the cover into place.
Light |
Cover |
Light |
14
