ELECTRICALSYSTEM

A

CAUTION!

 

Electrical

storage

batteries

 

 

give off

highly

inflammable

 

hydrogen

gas

when charging and continue to do so for some time after receiving a steady charge. Do not under any circumstances allow an electric spark or an open flame near the battery. Do not lay tools across battery terminals as this may result in a spark or short circuit which amy cause an ex- plosion. Be careful to avoid spilling any electrolyte on hands or clothing.

CAUTION! Acid or electrolyte should never be added except by a skilled battery man. Under no circumstances

add any special bettery "dopes", solutions, or powders.

use a spark plug wrench when removing or reinstalling the plug.

Be sure the gasket is in good condition, and screw plug in tightly. Do not tighten more than enough to compress the gasket to seal the plug and assure a good heat transfer between the plug and cylinder

head.

Replace defective plug with new plug. See your I nternational Harvester dealer for a correct replace- ment plug.

Spark Plug

Occasionally remove the battery cables and bright- en the terminal contact surfaces with wire wool, and reassemble. Apply a light coat of vaseline or chassis lubricant. Be sure terminals are clamped tightly, the rubber cover is slid over the positive terminal, and that battery is fastened securely in the battery box. Replace defective cable, and keep vent holes in battery filler caps open.

CAUTION! Wh.~n removing the battery cables, remove the white cable (ground) first and then the red cable from the

positive side of battery. Otherwise, sparks mayIt. result causing an accidel When reattaching or reinstalling the battery reverse the above pro- cedure.

Clean spark plug with a pen knife or wire brushand solvent. If electrode is burned away or the

porcelain is cracked, replace with new plug.

 

PLUG

 

 

 

 

 

 

 

NOTE: Remove all dirt from base of spark plug

 

 

 

before

removing.

 

 

 

 

Checking the spark plug gap.

 

 

 

 

 

 

 

 

 

 

 

 

 

Set gap at .O30-inch.

Remove the spark plug after every 100 hours of

 

 

 

operation for cleaning and checking the gap. Whenadjusting

 

 

 

the gap, always bend the outer electrode.

 

 

 

Never

bend the

insulator.

If gap

between

the

NOTE: Do

not

use abrasive cleaning machine;

electrodes is too

great, the

engine will

misfire

and

because any

grit

introduced into the engine could

be hard to start.

 

 

 

 

cause severedamage.

16

CleaningSPARKAlways

Page 17 Page 19
Page 18
Image 18
International Home Products Cadet 80 manual Head, Electricalsystem, Plug
Page 17 Page 19

Cadet 80 specifications

The International Home Products Cadet 80 is a standout model in the realm of energy-efficient heating solutions. Designed with the modern consumer in mind, this electric wall heater combines functionality, aesthetics, and reliability. Its sleek design allows it to fit seamlessly into any home decor, making it a versatile addition to varied spaces, whether in residential or commercial settings.

One of the primary features of the Cadet 80 is its compact size, which enables it to be installed in tight spaces without compromising performance. The heater's slim profile allows for discreet placement, ensuring that it complements rather than detracts from the room's appearance. With a capacity of 800 watts, this model is ideal for heating small to medium-sized rooms, delivering consistent warmth during colder months.

The Cadet 80 is equipped with advanced technologies that enhance user experience and efficiency. It incorporates an easy-to-use adjustable thermostat that allows homeowners to set their desired temperature with precision. This feature not only maximizes comfort but also contributes to energy savings, as the system can automatically adjust its output based on the room’s heating needs.

Another hallmark of the Cadet 80 is its safety features. The heater includes a built-in overheat protection mechanism, providing peace of mind for users. This feature automatically shuts off the unit if it becomes too hot, preventing potential hazards and ensuring safe operation. Furthermore, the durable, heavy-duty construction of the Cadet 80 ensures longevity, withstanding the rigors of daily use.

Additionally, the easy installation process of the Cadet 80 is worth noting. The unit can be hardwired directly into the electrical system, making it suitable for permanent installation in various settings. This eliminates the need for cumbersome cords and allows for a cleaner aesthetic.

In summary, the International Home Products Cadet 80 electric wall heater stands out for its compact design, efficient heating capacity, user-friendly controls, and emphasis on safety. For those seeking a reliable and stylish heating solution for small to medium rooms, the Cadet 80 presents an excellent choice, merging modern technology with practical features that enhance comfort and convenience.
Top Page Image Contents