23
User Manual
Fig. 3.1.12 - Fish Finder Alarms menu
3.1.12.1 Shallow Water
Triggers an alarm when depth becomes shallower than the value set.
3.1.12.2 Depth Water
Triggers an alarm when depth becomes deeper than the value set.
3.1.12.3 Temperature Upper
Triggers an alarm when the transducer reports a temperature (from TEMP 1 sen-
sor) above the value set.
3.1.12.4 Temperature Lower
Triggers an alarm when the transducer reports a temperature (from TEMP 1 sen-
sor) below the value set.
3.1.12.5 Temperature Rate
Triggers an alarm when the transducer reports a temperature (from TEMP 1 sen-
sor) variation rate above the value set.
3.1.12.6 Fish Alarm
The options for Fish Alarm set the size of the fish that, if detected by the unit,
switches an alarm to sound. These options are: Off, Small, Medium, Big and
Huge. The alarm sounds if the set size (or bigger) is detected.
3.1.13 Load Settings from User C-CARD
Load the complete settings from the User C-CARD and changes the active menu
settings.
Insert the User C-CARD into the slot, then follow the procedure:
[MENU] + "LOAD SETTINGS FROM USER C-CARD" + [ENTER]
3.1.14 Save Settings to User C-CARD
This is useful to avoid the user having to retune up Radar after a Clear RAM
operation or a software update.
Insert the User C-CARD into the slot, then follow the procedure:
[MENU] + "SAVE SETTINGS TO USER C-CARD" + [ENTER]
3.1.15 Restore Current Preset Defaults
This option restores the default values only for the current presets (see Par. 3.1.1,
Preset Mode) and does not affect the other presets. Follow the procedure:
[MENU] + "RESTORE CURRENT PRESET DEFAULTS" + [ENTER]
A confirmation window is shown. Select "YES" and press [ENTER] again.