(131) MODEL CS8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 07/28/2010

English 131

OPERATION INSTRUCTIONS

1.Turn on the filter pump.2.Start up the unit:

Plug the power cord into the electrical

outlet and test the GFCI/RCD (circuit breaker). Switch on the unit. Code “00” appears on

the electronic control station’s LED, indicating

that the unit is in a Stand-By Mode. This is normal.

3. Unlock keypad controls:

Press and hold the -- button for 2 seconds until you hear a short “beep”. Then press and hold the button for another 2 seconds until you hear the second short “beep”. The LED flashes “00”. This procedure unlocks the keypad control buttons.

4.Set operating hours for Saltwater system: Increase the scheduled number of operating

hours by pressing the button

. Or reduce

 

 

 

 

 

them by pressing the button

. See the

 

 

 

 

 

“Operating Time Table” for the required

 

 

 

 

 

operating hours related to each pool size.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Press the button

to select the desired

 

 

 

 

 

 

 

 

 

 

hours. You can press

if you have

 

 

 

 

 

selected too many hours. The built-in timer

 

 

 

 

 

will now activate your Saltwater System, at

 

 

 

 

 

the same time each day, for the number of

(1 to 12 hours max per cycle)

hours you have set.

 

 

 

 

 

 

 

 

NOTE: The Saltwater System will not operate if the filter pump is n ot operating. Make sure to program your filter pump (or start it manua lly) for operation beginning 5 minutes before the saltwater system and finishing 15 minutes after the saltwater system.

5. Lock keypad controls:

With the desired hour value showing, press and hold the button for 2 seconds until you hear a long “beep”. Then press and hold for another 2 seconds until you hear the second long beep. A green “WORKING” indicator on the control panel will light up within a few seconds to indicate that the saltwater system has started chlorine production. Locking the control buttons into this setting prevents unauthorized changing of the operating cycle.

NOTE: If you forget to lock the keypad controls, the system will automatically lock it and start working 1 minute later.

6.Readjust operating time if necessary:

The operating hours can be re-adjusted if necessary. Just repeat the steps 3 through 5.

7. Test the copper concentration in the

 

 

Copper (ppm)
pool water.

0

0.1 0.2 0.5 0.9 1.3

The Saltwater System recommends a

 

 

 

 

 

copper level of 0.1 to 0.2 ppm. This is

 

 

 

 

 

easily tested by the copper ion test strips

 

 

OK

 

 

 

 

 

provided. If the test result is 0.1~0.2ppm,

 

 

 

 

 

go directly to step 9.

 

 

 

 

 

 

 

 

 

 

 

OPERATING INSTRUCTIONS

SAVE THESE INSTRUCTIONS

Page 18