(131) MODEL CS8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 07/28/2010

English 131

OPERATION INSTRUCTIONS (continued)

8. Boost cycle

•If the test result is below 0.1ppm, press and hold “BOOST” button for 5 seconds until the indicator lights up and the LED display “80”. This indicates that the saltwater system has started copper ion production.

You can press and hold the “BOOST” button for another 5 seconds until the indicator is off, which will cancel the Boost cycle.

Note: Once the system has started copper ion production, the boost button can’t be re-set until the power switch is off.

•The boost operatinghours is4 times the amount oftime programmed into the system,i.e. if your saltwater system operating time is 2 hours, the boost procedure will run4 x 2 = 8 hours.After boost procedure has been completed, the system will automatically switch to the normal working mode.

•Once the boost is operating, check whether the filter pump operating hours have been set properly. For example, the boost operating time is 8 hours, the filter pump should be set to run for 8 hours at least. Increase the filter pump operating time if necessary.

Note: If an Intex filter pump is attached to the system, set the pump switch to on “I” position.

•After a heavy rain or if the pool is dirty, press the “BOOST” button to shock the pool again.

9. Test pool water regularly:

Once the copper level appears to be balanced, test the pool water every week to maintain the proper sanitizer level.

It’s very important that the free chlorine is between 0.4-1.5 ppm and copper ion concentration is between 0.1~0.2 ppm. When the copper level is below 0.1 ppm, repeat step 8.

NOTE: A High copper ion concentration may cause blonde hair to exhibit a green hair. To prevent this, wear a swimming cap during swimming, and wash hair with special shampoo after using the pool.

See “Troubleshooting Guide”.

10. Stand-by/power saving mode:

•When the cycle ends, the green “SLEEP” indicator on the control panel lights up and the LED display flashes “93”. The system is now in Stand-By mode. After a while, it shuts down and sets itself in a Power Saving mode. The system will automatically turn itself back on in 24 hours, starting its daily cycle of chlorine production.

•The “SLEEP” indicator stays on, while the system is in the Power Saving mode. The LED display however, goes blank

after 1 hour. Press any button (

or

) to view the last LED

code.

 

 

OPERATING INSTRUCTIONS

SAVE THESE INSTRUCTIONS

Page 19