Attaching the Kneepad

SECTION 2—ASSEMBLY

WARNING

The kneepad is an integral part of the lift and MUST be attached so that the lift can function correctly and safely.

CAUTION

When connecting the actuator to the boom, DO NOT over-tighten the bolt because this will deform the clevis and restrict the pivot.

NOTE: For this procedure, refer to FIGURE 2.2 on page 13.

1.Connect the top of the actuator to the boom using the bolt provided (Detail “A”).

2.Insert the two posts of the kneepad into the tube retainers of the kneepad receiver while turning the kneepad release lever in a clockwise direction (Detail “B”).

3.Release the kneepad release lever.

4.Slide the kneepad in or out until it is locked into position.

DETAIL “A”

Boom

Actuator

Bolt

	DETAIL “B”
Kneepad	Kneepad	Tube
Release	Receiver	Tube
Lever		Retainer	Kneepad
		Post	Kneepad
		Post
Tube
Retainer	Post

FIGURE 2.2 Attaching the Kneepad

Part No 1141431

Reliant™ 440

Invacare 440 manual Attaching the Kneepad

Models: 440

Attaching the Kneepad

FIGURE 2.2 Attaching the Kneepad